Payne PA10 Series Product Data
MODEL PA10
10 SEER 3-PHASE AIR CONDITIONER
Product Data
FEATURES
AVAILABLE SIZES: Nominal sizes available (036, 048 and 060) to
CERTIFICATION:
ELECTRICAL RANGE: 208/230v, three phase in 036, 048 and 060
FAN MOTOR:
CABINET:
UNIT DESIGN:
meet the needs of light commercial applications.
All models are listed with UL, (U.S. and Canada), ARI, and CEC.
sizes; and 460v, three phase in 060 size.
The totally enclosed fan motor provides greater
reliability under adverse conditions and dependable performance for many years. The permanent
split capacitor type motor was designed for optimum efficiency. The motor was then qualified
under extreme conditions to help ensure a long,
reliable life.
A weather protective cabinet of prepainted steel is
protected underneath by a galvanized coating and
treated with a layer of zinc phosphate for a finish
that will last for many years. All screws on cabinet
exterior are coated for a long-lasting, rustresistant, quality appearance.
The copper tube, enhanced sine wave, aluminum
fin coil is designed for optimum heat transfer. Vertical air discharge carries sound and hot condenser air up and away from adjacent patio areas
and foliage. The base pan is designed for easy
removal of water, dirt, and leaves.
COMPRESSOR:
3-PHASE
(SCROLL
COMPRESSOR
UNITS) MONITOR
BOARD:
SERVICE VALVES: Control board that monitors the electrical phase
SERVICEABILITY: One panel provides access to electrical controls.
LIMITED
WARRANTY:
Each compressor is protected with internal temperature- and current-sensitive overloads. An
internal pressure relief valve provides highpressure protection to the refrigerant system. For
improved serviceability, all models are equipped
with a compressor terminal plug.
Both service valves are brass, front seating type
with sweat connections. Valves are externally
located so refrigerant tube connections can be
made quickly and easily. Each valve has a service
port for ease of checking operating refrigerant
pressures.
and prevents compressor operation if wired
incorrectly.
Removal of top gives access to fan motor, compressor, and condenser coil.
Standard 1-year limited warranty on parts and 5year limited warranty on compressor.
E
SOUND POWER (dBA) (A-wtd., non-pure tone corrected.)
UNIT
SIZE
036-A 82 55.0 64.0 73.0 74.5 72.0 60.5 64.0
048-A 82 61.9 67.5 71.8 77.1 76.5 72.9 66.9
060-A 82 58.0 67.5 78.0 76.0 76.0 73.0 67.0
NOTE: Tested in accordance with ARI standard 270.95. (Not listed with ARI.)
SOUND
LEVEL
125 250 500 1000 2000 4000 8000
PA10
OCTAVE BAND CENTER FREQUENCY (Hz)
ISO 9001:2000
REGISTERED
Type of Unit
PA10 – Electric Air Conditioner
Electrical Supply
P — 208/230-3-60
— 460-3
Refrigerant–R22
MODEL NUMBER NOMENCLATURE
PA10 P R
036 000 A A AA
Variations
Series
Variation
A — Standard Unit
Heating Capacity
Nominal Cooling Capacity
036 – 3.0 Tons
048 – 4.0 Tons
060 – 5.0 Tons
—2—
SQ
A
AIR DISCHARGE
-IN. DIA HOLE
8
/
-IN. DIA KNOCKOUT
8
/
3
-IN. DIA KNOCKOUT
8
/
-IN. DIA HOLE WITH
1
8
/
FIELD POWER SUPPLY CONN
7
AND 1
1
7
FIELD CONTROL SUPPLY
CONN
-IN. DIA LIQUID
8
/
LINE CONN
3
Pad Dim
Min Mounting
C
/8″
7
2
/4″
1
1
PA10
AIR DISCHARGE
AIR IN
M
DIA VAPOR LINE CONN
D
P
B
AIR IN
L
NOTES:
1. Allow 30 in. clearance to service side of
unit, 48 in. above unit, 6 in. on one side, 12 in.
on remaining side, and 24 in. between units for proper airflow.
2. Minimum outdoor operating ambient in cooling mode is
55°F, max. 125°F.
3. Series designation is the 14th position of the unit
model number.
4. Center of gravity .
DIMENSIONS (IN.)
K
J
AIR IN
H
G
F
E
N
/8-IN. DIA
AIR IN
TIEDOWN
3
(2) PLACES
KNOCKOUTS
AIR DISCHARGE
—3—
036 A 22-1/2 25-15/16 3-3/16 3/4 3-11/16 18-1/8 19-3/4 22-1/4 14-3/8 19-9/16 22-1/16 10-3/8 10-3/4 11 22-1/2 x 22-1/2
SIZE SERIES A B C D E F G H J K L M N P
UNIT
The data in this publication is displayed for all series, however, every series may not be available from manufacturer.
048 A 22-1/2 33-15/16 3-1/4 7/8 3-11/16 18-1/8 19-13/16 22-1/4 14-3/8 19-9/16 22-1/16 10-3/8 10-3/4 15-1/2 22-1/2 x 22-1/2
060 A 30 29-15/16 3-1/4 7/8 6-1/2 23-1/2 27-1/4 29-3/4 20 27-1/16 29-9/16 15-1/2 14 15 30 x 30
NOTE:
METERING DEVICE
UNIT SIZE-SERIES
036-A 70
048-A 82
060-A 93
* Piston listed is for any approved coil non-capillary tube combination.
Piston is shipped with outdoor unit and must be installed in an approved indoor coil.
UNIT SIZE 036
SERIES A A A A
PA10
Operating Weight (Lb) 122 154 214
Shipping Weight (Lb) 141 175 236
ELECTRICAL
Unit Volts—Hertz—Phase 208/230-60-3 208/230-60-3 208/230-60-3 460-60-3
Operating Voltage Range* 187-253 187-253 187-253 414-506
Compressor—Rated Load Amps 10.0 12.8 16.0 8.0
Locked Rotor Amps 70.0 91.0 125.0 66.5
Condenser Fan Motor—Full Load Amps 1.4 1.4 1.4 0.8
Min Unit Ampacity for Wire Sizing 13.9 17.4 21.4 10.8
Min Wire Size (60°C/75°F Copper) AWG† 14/14 14/14 12/12 14/14
Max Wire Length (60°C/75°F) (Ft)‡ 65/62 52/49 66/63 165/157
Max Branch Circuit Fuse Size** 20 30 30 15
COMPRESSOR & REFRIGERANT
Compressor—Type Reciprocating Scroll
Temperature and Current Protection Internal Line Break
Refrigerant—Type and Amount (Lbs) R-22 5.00 R-22 6.25 R-22 8.31
Refrigerant Tubes (In. OD)
Vapor and Liquid (Up to 50 Ft) 3/4 and 3/8 7/8 and 3/8 1-1/8 and 3/8
CONDENSER COIL & FAN
Coil Face Area (Sq Ft) 9.1 12.4 18.5
Fan Motor—HP, Type, and RPM 1/4 PSC and 1100 1/4 PSC and 1100
Volts—Hertz—Phase 208/230—60—1 208-230—60—1 460—60—1
Condenser Airflow (CFM) 2500 2500 3400
OPTIONAL EQUIPMENT
Cycle Protector KSACY0101AAA
Low-Pressure Switch KAALP0101LPS
High-Pressure Switch KSAHI0101HPS
Time-Delay Relay KAATD0101TDR
Winter Start Control KAAWS0101AAA
Evaporator Freeze Thermostat KAAFT0101AAA
Compressor Crankcase Heater KAACH1001AAA KAACH1201AAA KAACH1301AAA
Liquid Line Solenoid Valve KAALS0101LLS KAALS0101LLS
Filter Drier P502-8083S P502-8163S
MotorMaster® Control 32LT660004 32LT660005
Ball Bearing Fan Motor HC40GE232 HC40GE462
Low-Ambient Pressure Switch Kit KSALA0201R22
Compressor Sound Hood KSASH1201COP KSASH2001CYL
TXV (Hard Shutoff) KSATX0601HSO KSATX0701HSO KSATX1001HSO
Thermostat, Manual Changeover,
Non-Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool‡‡ TSTATPPBAC01-B
Thermostat, Manual Changeover,
5-2-Day Programmable, °F/°C,
1-Stage Heat, 1-Stage Cool TSTATPPSAC01-B
Backplate for Standard Thermostat TSTATXXBBP01
Backplate for Programmable Thermostat TSTATXXPBP01
Outdoor Air Temperature Sensor TSTATXXSEN01-B
* Permissible limits of the voltage range at which unit will operate satisfactorily. Operation outside these limits may result in unit failure.
† If wire is applied at ambient greater than 30°C (86°F), consult Table 310-16 of the NEC (ANSI/NFPA 70).
The ampacity of nonmetallic-sheathed cable (NM), trade name ROMEX, shall be that of 60°C (140°F) conductors, per the NEC (ANSI/NFPA 70) Article
336-26.
‡ Length shown is as measured 1 way along wire path between unit and service panel for voltage drop not to exceed 2%.
** Time-delay fuse or circuit breaker.
‡‡ Furnace model numbers P08UA, P08LA, and PG8HA are not compatible with this thermostat.
N/A—Not applicable in this application.
NOTES: 1. Control circuit is 24v on all units and requires external power source.
2. All motors/compressors contain internal overload protection.
3. Copper wire must be used from service disconnect to unit.
IDENTIFICATION NO.
PISTON*
SPECIFICATIONS
—4—
CHARGING SUBCOOLING
(TXV-TYPE EXPANSION DEVICE*)
UNIT SIZE
036 15
048 15
060 15
048 060
REQUIRED SUBCOOLING
(°F)
Loading...