Paxton EM4100 User Manual
16/11/2011
Ins-30082 OEM PROXIMITY architectural reader EM4100 Wiegand output
Suitability
Security-sensitive doors
Accepts customised inserts and bezels
Readers mounted together
Wet environments
300 mm
between readers
Fitting
Ensure that the backbox is mounted vertically and is square with the wall surface.
Care must be taken when doing this, as no further 'twist' adjustment is possible within the reader mountings.
Reader insert
The reader insert is held against the backplate by an outer decorative bezel secured with 4 small screws.
Remove these screws to release the bezel and ret after adding the insert.
If you have made an insert of less than 5 mm thick, this can still be tted by using the 3 nylon screws supplied
in the tting kit to hold the insert against the bezel. (see diagram)
Mounting the reader
Line up the two locating pins on the top of the
reader with the top plate inside the backbox.
Once located, the reader can be clipped into the
box at the bottom using the clip feature.
Check that the reader is located against the
surface of the wall. If there is a gap between
the reader and the wall, or if the reader will
not successfully clip into the box, remove the
reader and adjust the mounting plates inside the
backbox using a 3 mm Allen key.
Removing the reader
To remove the reader, insert the
tool provided into the cut out
on the underside of the reader.
Push up the clip and pull the
reader from the backbox.
Wire outputs
+12V DC
Red LED
Amber LED
Green LED
Data 0
Data 1
Not required
0V
Cable extensions
Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.
Specications
Environment
Operating temperatures - all items
Waterproof
Cable length
Electrical
Voltage
Current
Carrier frequency
Wiegand format
Dimensions
Reader
Backbox
Reader insert
Read Range
Min
-20 °C
Min
8V DC 14V DC
Width
70 mm 110 mm
60 mm 100 mm
61 mm 102 mm
Token
40 mm 25 mm
Max
+55 °C
Max
140 mA
Height
Keyfob
IPX7
5 metres
125 kHz
26 bits
Depth
10 mm
25 mm
6 mm
Hands Free Token
400 mm
Contents in box
PROXIMITY architectural reader - Wiegand
Backbox assembly
Reader junction box
Reader insert diagram
Instruction set
Fitting kit
Kit fk1-080 4 No 8 x 1in pozi pan self tapping screw - zinc
Qty
4 35mm wall plugs
3 M3 x 10 nylon screw
1 Reader removal tool
Description
Loading...