Paxton EM4100 User Manual
28/10/2009
Ins-30083 OEM PROXIMITY marine reader EM4100 Wiegand output
Suitability
Security-sensitive doors
Mounted on metal surface
Readers mounted together
Wet environments
300mm
between readers
Fitting
Fix the backplate to the wall with the stainless steel screws provided in the tting kit. The small slot in the
plate edge should be positioned at the bottom.
Where the unit is to be tted to a smooth surface, bulkhead, etc. a gasket is supplied to provide a
weatherproof seal between the backplate and the mounting surface. (The unit has its own integral seal)
Locate the unit in the keyhole slots provided in the backplate. Make sure that the locking pin is close to the
slot in the edge of the backplate. Rotate the unit clockwise until the locking pin engages in the slot.
Removing the reader
To remove the unit, insert a small screwdriver into the cut out provided and use it to lift the locking pin.
The unit can then be rotated anticlockwise to release it from the backplate.
Cable extensions
Readers can be extended using Belden CR9540 10-core overall screened cable to a maximum of 100 metres.
Wire outputs
+12V DC
Brown
LED
Output condition table
Brown
Orange
Green
Orange
Green
Data 0
Data 1
Not Required
0V
OFF
The active display on the marine reader is used to produce a blue backlight as well as green and red
indications. This is controlled by the brown, amber and green wires. Pulling these wires to ‘0V’ individually
or in combination will produce the colours as per the LED condition table.
Backlight dimming card
The backlight on the unit may be dimmed down or turned off if required. A dimming card is provided with this unit.
Present this card within 2 minutes of powering up the reader and the backlight (blue) will reduce in brightness.
Repeated presentations will reduce the brightness in stages down to no illumination. Showing the card again will
return the backlight to full power.
Specications
Environment
Operating temperature
Waterproof
Cable length
Electrical
Voltage
Current
Carrier frequency
Wiegand format
Read Range
EM4100 tokens
Dimensions
Min
-25 °C
Min
8V DC 14V DC
Token Keyfob
40 mm 30 mm 400 mm
Diameter
106 mm 16 mm
Max
+55 °C
IPX7 Outdoor Use
Max
220 mA
Hands Free Token
Depth
Contents in box
PROXIMITY marine reader - Wiegand
Reader backplate
Backplate gasket
Backlight dimming card
Reader junction box
Instruction set
Fitting kit
Kit fk1-079 3 No 8 x 1.5 in pozi pan self tapping screw - zinc
Qty
3 Wall plugs
Description
5 metres
125 kHz
26 bits
Loading...