PAX Technology PX7RF User Manual

P 5 & PX7 Payment TerminalX

Compliance

PAX TE CHNOL OGY INC .

Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment. In a domestic
environment, this product may cause radio interference in
which case the user may be required to take adequate
measures.

FCC Regulations

FCC Regulations

1

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.

This device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.

If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and
receiver.

• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician
for help.

RF Exposure InformationRF Exposure Information

This device meets the government’s requirements for
exposure to radio waves.
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the U.S.

Government.
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment.

PAX TECHNOLOGY INC.

PAX TE CHNOL OGY INC .

20 0 3 1 2 0 00 00 0 23 0

This document is provided to you for informational purposes only.

All features and specifications are subject to change without notice.
PAX's name and PAX's logo are registered trademarks of PAX
Technology Inc. All rights reserved.

PAX Technology Inc.

4901 Belfort Road, Suite 130
Jacksonville, FL 32256, USA
T: 877-859-0099
W: www.pax.us
E: [e-mail]

IC NoticeIC Notice

This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:

(1) this device may not cause interference, and
(2) this device must accept any interference, including

interference that may cause undesired operation of the
device.

Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible
d'en.

This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la

norme NMB-003 du Canada.

IC Radiation Exposure StatementIC Radiation Exposure Statement

4

This EUT is very low power and complies with IC CNR-102
exemption requirements.

Ce MAE est très faible puissance et de la conformité aux
exigences d'exemption IC CNR-102.
PX7 FCC ID：V5PPX7RF

IC：11689A-PX7RF

PowerPower

5

If a power supply was not shipped with the P terminal or if
there is not an immediately available power supply to
use with the P terminal, use the following guidelines
when selecting and using a suitable power supply:

x

x

Must use PAX Power Supply (Material No.

200310110000070) and PAX Power Cord (Material No.

200311020000023), or

Must use a suitable safety listed power supply, output
rated 9Vdc 1A or greater and must be a certified
Limited Power Source marked “LPS”.

When so powered, this device is intended to be connected
only to Power over Ethernet (PoE) networks that are not
routed to the outside plant.

• UL 60950

• RoHS

• PCI PTS 4.x

• PCI PA-DSS

(

+

)

-