PAX Technology D2204GMA User Manual

PAX D220 Mobile Payment Terminal
1. Contents Checklist
Mobile Payment Terminal 1
AC Power Adapter 1
Micro USB cable 1
Product Manual 1
. Installation
2
Micro SAM/SIM Card
a) Remove the bottom cover.
b) Insert the Micro SAM/SIM card to the corresponding card slot.
1) Power ON/OFF
Power on: Plug in power adapter, Press Power ON/OFF button for 5 seconds, and then PAX
LOGO will display on LCD.
Power off: Press Power ON/OFF button for 3 seconds until Shutting down... can be seen. Forced shutdownPress Power ON/OFF button more than 6 secondsuntil the screen no
display, that is forced to shut down.
2) IC Card
Put IC card chip side upward, push-in IC card slot and to bottom.
3) Contactless Card
The card read area is above the LCD, Put the card above the LCD.
4) Battery Charge display
Connecting USB port with external adapter can charger battery. And there are charging
display.
5) Battery Charge style
Please use the original adapter instead of pc usb port if you need to charge.
4. Installation and Usage Tips
1Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment. 2Forbid non-professional to repair the terminal. 3Before insert the card, please check internal and around of IC card slot. when you found some
suspicious objects , must report to related administrator.
5. Lithium Ion Battery Usage Tips
WARNING: 1Don't use the battery in sunlight or smoke, dust environment. 2Prohibited to strike, squeeze and tread on battery or throw it into the liquid and fire. 3If battery is impressive, deformed, damaged or exothermic seriously, please stop using
immediately and replace it! 4If the continuous working time is only half of new one, the battery life may be end. Please
replace it! 5Must use the specified battery model and charger, otherwise there will be explosion 6Charging time can not exceed 24 hours. If the battery is out of power, please recharge in time.
Avoid damaging the battery in over-charge and over-discharge. 7)If be non-use for long time, please recharge the battery per 6 months to avoid shortening its life. 8Suggest to replace it when the battery have been used for 2 years. 9Be sure to follow the instructions to dispose the wasted batteries.
Icon shows
Do not throw away, need professional recycling.
Class II Equipment
For indoor use only
Energy Efficiency Marking
AC voltage
DC voltage
The full text of the EU declaration of conformity is available at the following internet address
http://www.pax.com.cn/ProductCE.aspx
P/N200312000000117
FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiated radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Loading...
+ 3 hidden pages