
USER
MANUAL
MODEL 536S
802.5 Token Ring (STP)
Surge Protector
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
http://www.patton.com
Part# 07M536S
Doc# 074171U
,
Rev. B
Revised 1/22/08
CERTIFIED
An ISO-9001
Certified Company

1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 536S components to be free
from defects, and will—at our option—repair or replace the product
should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials, and
does not cover customer damage, abuse or unauthorized modification.
If this product fails or does not perform as warranted, your sole recourse
shall be repair or replacement as described above. Under no condition
shall Patton Electronics be liable for any damages incurred by the use
of this product. These damages include, but are not limited to, the
following: lost profits, lost savings and incidental or consequential
damages arising from the use of or inability to use this product. Patton
Electronics specifically disclaims all other warranties, expressed or
implied, and the installation or use of this product shall be deemed an
acceptance of these terms by the user.
1.1 SERVICE
All warranty and non-warranty repairs must be returned freight
prepaid and insured to Patton Electronics. All returns must have a
Return Materials Authorization number on the outside of the shipping
container. This number may be obtained from Patton Electronics
Technical Service at: (301) 975-1007; http://www.patton.com; or,
support@patton.com.
Note: Packages received without an RMA number will not be
accepted.
Patton Electronics' technical staff is also available to answer any
questions that might arise concerning the installation or use of your
Model 1092. Technical Service hours: 8AM to 5PM EST, Monday
through Friday.
2.0 GENERAL INFORMATION
Thank you for your purchase of this Patton Electronics product.
This product has been thoroughly inspected and tested and is warranted
for One Year parts and labor. If any questions or problems arise during
installation or use of this product, please do not hesitate to contact
Patton Electronics Customer Service at (301) 975-1007.
1

3.0 INSTALLATION
Patton's Model 536S units are easy to install and should give you
years of trouble-free service. Here are a few simple instructions to help
you get things hooked up right:
1. Unplug (disconnect) the existing connection between the network
cable and the equipment’s I/O port.
2. Install the Model 536S between the incoming network cable and the
protected equipment using the 6” (15.24cm) modular patch cable
(supplied). Place the surge protector as close as possible to the
device being protected.
3. Connect the braided ground strap directly to a chassis ground
connection on the protected device. If you are unsure where to
locate a chassis ground connection on your equipment, consult the
equipment's user manual or contact the manufacturer—the ground
connection is critical for proper operation of the Model 536S.
3
Output to protected
equipment
input from
network
Connection to
frame ground