Patton 9200, 9100, 9300 User Manual

OnSite Models 9100, 9200, & 9300

Expansion Modules

Quick Start Guide

Part Number: 07M9000-QS, Rev. A
Revised: November 20, 2009

Sales Office: [phone]

Technical Support: [phone]

E-mail: [e-mail]

WWW: www.patton.com

WARNING

Read the safety information in the OnSite Series
and

Administrator’s Reference Guide

operating your OS-10 Series system. Failure to follow this safety infor­mation can lead to personal injury or damage to the equipment.

thoroughly before installing and

Getting Started Guide

1.0 Introduction

This guide provides instructions for adding expansion modules to your Patton OnSite base system. Refer to the
following sections for installation instructions for your specific module:

2.0 “Model 9100 E1 Module”

•

3.0 “Model 9200 Ethernet Module”

•

4.0 “Model 9300 STM-1 Module”

•

on page 2

on page 4

on page 5

2.0 Model 9100 E1 Module

2.1 Unpacking and Installation

To install the HD-E1 module, follow the procedures in Chapter 7 of the

Guide

. Figure 1 shows the alignment and insertion of the HD-E1 module into one of the available expansion slots

OnSite Series Administrator’s Reference

of the OS-10.

The High-density E1 module is NOT hot swappable. You will need to
power down the OS-10 system before starting the module insertion pro­cedure.

CAUTION

Figure 1.

2

Installing the HD-E1 module

OnSite Expansion Modules Quick Start Guide

2.2 Cable Management

The HD-E1 module uses a future bus connector on the front panel and requires the use of cables with compatible
plugs for access to the E1 signals. These cables are ordered separately from the module and need to be specified
according to the termination option for the module (75-ohm or 120-ohm) and the required cable length for the
site.

Note

Contact your local Patton sales representative if the shipment does not include the required cables for
the module.

Chapter 7 of the

OnSite Series Administrator’s Reference Guide

provides information on the location and signal
pin-out for each of the 21 E1 ports on the future bus connector. Each module requires six cables for access to all
21 E1 ports. When installing the cables, make sure that the cable bundle does not cause strain on the future bus
connector by pulling it up or down or sideways. You may tie the cable bundle together using a strap, as shown in
Figure 2, to create a strain relief bend. In addition, use another strap, as shown in Figure 2, to tie the cable bun­dle to the rack post. This additional strap secures the cable bundle in place and prevents accidental movement

that may cause strain to the connector.

Make sure that cable plug has the correct orientation before inserting the
plug into the module. The plug should be inserted within a single section
of the future bus connector with the release latch facing down. (The mod-

CAUTION

ule has six, 24-pin connector sections.) The plug should snap into place
smoothly without the use of force. Wrong insertion may bend the connec­tor pins.

Figure 2.

OnSite Expansion Modules Quick Start Guide

Cable dressing for the HD-E1 module

3