Button & Slider Station
Quick
Assembly
Guide
2. cont’d
Identify the Master insert. Masters have either an RJ45
1.
connector or two six-pin headers.
Hold the Master in your left hand and the 8-pin connector in
your right. Angle the connector slightly to visually locate the
pin receptacles, then push the pins into the female connector inside the unit.
If you do not feel the pins engage into the connector right
away, try slightly wiggling the 8-pin in your right hand until
you feel the pins locate themselves.
Pins
Front View
Bottom View
Verify proper contact by looking at the pins between the
3.
two inserts.
If misaligned, the pins will likely be resting at an angle,
and will not make contact with the internal connector. In
this case, pull the two inserts apart (see step 4) and try
again.
Bottom view
Repeat process for each additional Slave.
Once complete, plug in cabling and test before mounting
assembled station into place.
Within the first ten seconds of powerup, all LEDs on every
insert should flash.
Pins
Pins
Bottom View
Hold the Master in your left hand and the first Slave unit in
2.
your right. The Slaves have three tabs along their left sides
that will help align the inserts.
Keep the two inserts as straight and square to each other
as possible, and with the tabs aligned, push them directly
towards each other.
You should feel some light resistance as the pins butt up to
the connector inside, and the tabs will snap together as the
pins make contact with the receptacle.
Side View
If Slave LEDs do not flash, proceed to step 4 and try
again.
To separate two inserts, hold one in each hand with your
4.
fingers on the rear of the inserts and your palms on the
front. Gently pry them apart in the direction of the arrows
below. The tabs will disengage, at which point you may
pull them apart.
6.6.17
Loading...