Passtime USA DDD1RX User Manual

INSTALLATION DIAGRAM

The Distracted Driving Device (DDD) system is comprised of two separate devices, the DDD
Communication Device (PTE-5) and the DDD Handset Dock (DDD-1). Both devices will need to be
installed in the vehicle as shown in this document.

WIRING DIAGRAM

Key

Pink (Ignition)

Comm Device (PTE-5) Dock (DDD-1)

Black (Ground)

OBDII

hot while engine
cranking

Red (12v Constant)

Pin16Pin 4

Blue (Starter In)

(Cut)

Purple (Starter Out)

Starter Control Circuit

Fuse

Starter

If you are making the connecons directly at the baery, you MUST use a 3A size inline fuse
(as shown). This is a safety precauon in the case of a nicked or pinched wire contacng
metal.

STEP 1: INSTALL COMM DEVICE

POTENTIAL INSTALLATION LOCATIONS

The Comm Device (PTE-5) should be
installed as high in the dash as possible to
ensure the best performance and to help
prevent tampering.

• Above or behind instrument cluster

• Above any accessible air vents

• Above or behind the radio

Note: When mounng the device, the LED’s must be facing up and the device should not be obstructed by metal.

Page 1

© 2017 Distracted Driving Device, LLC.
No party may republish, copy, redistribute, sell or offer for sale to any third party this material or any part of it without express written
permission of the authors.

DEVICE HARNESS ELECTRICAL
CONNECTIONS

NOTE: For all connections, soldering is recommended.
Posi-tap and butt connectors are also acceptable (as
shown).

GROUND - Aach to a secured bare metal chassis
ground locaon such as to a new or exisng threaded
fastener, or to a grounded circuit such as Pin 4 of the
OBDII connector (as shown).

12v CONSTANT - Any 12v constant source, that is not
being monitored by the computer for voltage draw, can
be used, like Pin 16 of the OBDII connector (as shown).
Use inline fuse if going direct to the baery.

NOTE: In late model vehicles, starter and ignition connections
should be made under hood, near main fuse relay. If harness wires
are not long enough, use 3-in-1 wire or equivalent to extend
harness (as shown).

IGNITION WIRE

NOTE: When making these
connecons, use grommets if wires
must penetrate the firewall and
use adequate looming if placing

STARTER WIRE

wires in the engine compartment
to protect from hot metal surfaces
and corrosive liquids.

IGNITION WIRE- a wire with 12V in “key on” and
“crank” posions.

STARTER WIRE - the wire with 12V in “crank”
posion only. Once the starter wire is cut,
connect Harness blue wire to key side of starter.
Connect Harness purple wire to solenoid side.

Page 2

© 2017 Distracted Driving Device, LLC.
No party may republish, copy, redistribute, sell or offer for sale to any third party this material or any part of it without express written
permission of the authors.