Page 1
Instruction Sheet
for the PASCO
Model SE-7256
012-08901B
Motion Sensor Guard
Note: The Motion Sensor Guard is designed to
protect the sensor from light objects such as a
foam ball, coffee filters, or a tennis ball. Heavy
objects may break the guard and damage the
motion sensor.
Introduction
The SE-7256 Motion Sensor Guard is designed to protect
the P ASCO Motion Sensor from falling objects. When
placed over the motion sensor, the wires of the guard are
within the 15 cm “dead zone” of the sensor. Therefore,
the wires do not interfere with data collection for position,
velocity or acceleration measurements.
Setup Instructions
1 . Set the Motion Sensor on a flat surface
2. Rotate the sensor head to point upwards
3. Place the Motion Sensor Guard over the Motion
Sensor as shown.
4. Be sure to position the guard so the intersections
of the wires are not directly above the sensing
element. This will minimize any interference by the
guard.
Position the guard so that the
intersections of the wires are not directly
above the sensing element.
Sensing
Element
Page 2
Motion Sensor Guard 012-08901B
Warranty
For a description of the product warranty, see the
warranty description in the PASCO catalog or on the
PASCO web site at www.pasco.com.
Copyright
The PASCO scientific Model SE-7256 Motion Sensor
Guard instruction sheetl is copyrighted and all rights
reserved. However, permission is granted to non-profit
educational institutions for reproduction of any part of
the instruction sheet providing the reproductions are
used only for their laboratories and are not sold for
profit. Reproduction under any other circumstances,
without the written consent of PASCO scientific, is
prohibited.
Technical Support
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7011
Phone: (916) 786-3800 or toll-free in the US
(800) 772-8700
FAX: (916) 786-7565
email: techsupp@PASCO.com
web: www.pasco.com
2
Loading...