PASCO PS-2577 User Manual

Instruction Sheet

SPARKlink Air Charging Station

Power Input Jack

SPARKlink Air Charging Station

PS-2577

012-13897A

Introduction

The PASCO model PS-2577 SPARK Charging Station is
designed to work with a PASCO PS-2011 SPARKlink Air. The
Charging Station can hold up to five SPARKlink Air’s at one
time. It takes approximately five hours to fully charge five SP AR­Klink Air’s.

The SPARKlink Air Charging Station includes a 20 watt switch­ing power adapter (100 - 240 VAC input and 5 VDC, 4.0 A out­put).

800-772-8700 www.pasco.com

Operation

Connect the plug from the power adapter to the power input jack
on the Charging Station. The power input jack is at the midpoint
on the upper left edge of the station. Connect the power cord
from the power adapter to a compatible electrical receptacle.

Make sure that the SPARKlink Air is OFF before inserting it into
one of the slots of the Charging Station. Insert as many as five
SPARKlink Air Systems. Because the Charging Station has a
fixed regulated power suppy, it does not matter how many of the
five slots are filled with SPARKlink Air Systems.

As the SPARKlink Air is charging, the light emitting diode
(LED) on the top right hand end of the SPARKlink Air will flash
red. When the SPARKlink Air is fully charged, the LED will
shine green continuously. The SP ARKlink Air’s charging cir­cuitry will disconnect itself from the battery when fully charged.

Model No. PS-2577 Storage

SP ARKlink Air

Charging Station with five

SPARKlink Air

’s

(not included)

Storage

Product End of Life Disposal Instructions:

This electronic product is subject to disposal and recycling regu­lations that vary by country and region. It is your responsibility to
recycle your electronic equipment per your local environmental
laws and regulations to ensure that it will be recycled in a manner
that protects human health and the environment. To find out
where you can drop off your waste equipment
for recycling, please contact your local waste
recycle/disposal service, or the place where you
purchased the product.

The European Union WEEE (Waste Electronic
and Electrical Equipment) symbol (to the right)

and on the product or its packaging indicates
SPARKlink Air Systems can be stored in the SPARKlink Air
Charging Station for long periods of time without harming the
battery. The SPARKlink Air circuitry monitors the battery level,
and when it falls below a certain level, the circuitry will start
charging the unit. When the battery is fully charged, the
SPARKlink Air charging circuitry will stop charging the unit.

that this product must not be disposed of in a standard waste

container.

Warranty and Copyright

For more information about the SPARKlink Air Charging Station

and the latest revision of this Instruction Sheet, visit:

Technical Support

For assistance with any PASCO product, contact PASCO at:

Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone: [phone] (worldwide)

800-772-8700 (U.S.)
Fax: [phone]
Web: www.pasco.com
Email: [e-mail]

www.pasco.com/go?PS-2577

Limited Warranty For a description of the product warranty, see the
PASCO catalog. Copyright The PASCO scientific 012-13897A SPAR-
Klink Air Charging Station Instruction Sheet is copyrighted with all rights
reserved. Permission is granted to non-profit educational institutions for
reproduction of any part of this manual, providing the reproductions are
used only in their laboratories and classrooms, and are not sold for profit.
Reproduction under any other circumstances, without the written consent
of PASCO scientific, is prohibited. Trademarks PASCO and PASCO
scientific are trademarks or registered trademarks of PASCO scientific, in
the United States and/or in other countries. All other brands, products, or
service names are or may be trademarks or service marks of, and are
used to identify, products or services of, their respective owners. For more
information visit www.pasco.com/legal.

2