Instruction Manual
Manual No. 012-09146A
Motion Sensor
Bracket
Model No. PS-2546
Model No. PS-2546 Motion Sensor Bracket
®
2
Model No. PS-2546 Motion Sensor Bracket
Motion Sensor Bracket
Model No. PS-2546
Introduction
The Motion Sensor Bracket is designed to hang a PASCO Motion Sensor vertically
or horizontally from any magnetic metal surface.
Setup Instructions
Hanging from the Ceiling
1. Screw the Motion Sensor Bracket into the Motion Sensor. Note: The thumb screw prevents
the Motion Sensor from rotating.
2. Place the magnet of the Bracket on a flat metal area of the ceiling. See the photo below
.
3. Rotate the sensor head to point downward.
®
3
Motion Sensor Bracket Model No. PS-2546
Mounting Horizontally
1. Screw the Motion Sensor Bracket into the Motion Sensor.
2. Attach the magnet of the Bracket to a flat metal area, such as the side of a filing cabinet.
See photo below.
3. Turn the Motion Sensor and rotate the sensor head until it points in the appropriate
direction. Note: To help stabilize the Motion Senso r, it may be necessary to wrap the cord
over the Motion Sensor so that it hangs from the opposite side.
4. Tighten the thumb screw against the Motion Sensor to prevent it from rotating.
Note: The Motion Sensor Bracket is designed to support only a Motion Sensor and
its cord. It is NOT recommended to support heavier objects to the Motion Sensor
Bracket. In addition, when the Motion Sensor Bracket is attached to the Motion
Sensor and is mounted from the ceiling, do not pull on the Motion Sensor or its
cord.
4
®
Loading...