Instruction Sheet
USB Charger
Storage Area
USB Port for
Power Cable
USB Charging Cable
for Smart Cart
Storage Spaces for
Smart Cart Accessories
Hook Attachment
Magnetic Bumper
Rubber Bumper
Storage Slot for USB Charging
Cable Plug
Tabs for USB Power Cable
Storage
Smart Cart Charging Station
ME-1243
012-15277A
Introduction
The PASCO ME-1243 Smart Cart Charging Station is
designed to work with the PASCO ME-1240 or ME-1241
Smart Carts. The Charging Station can hold up to five
Smart Cart’s at one time. It takes approximately five hours
to fully charge five Smart Carts.
PS-2575 Single Port USB Wall Charger
The Smart Cart Charging Station includes a two meter long
USB cable (USB-A to Micro-B) and the PS-2575 Single
800-772-8700 www.pasco.com
Port USB Wall Charger. The charger includes a power
adapter and four interchangeable plugs.
The Smart Cart Charging Station has built in storage
spaces for the Smart Cart Accessories (Hook Attachment,
Magnetic Bumper, and Rubber Bumper). The station also
ME-1243 Operation
has a storage area for the single port USB wall charger.
Along the top of the station are five small slots for storing
the charging plugs when they are not being used.
status LED on the Smart Cart will indicate what is happen
ing to the battery. The battery status shines yellow when
the battery is charging, and shines green when the cart is
charged. Insert as many as five Smart Carts. The Smart
Cart Charging Station has a fixed regulated power suppy
so it does not matter how many of the five slots are filled
with Smart Carts.
The Smart Cart’s charging circuitry will disconnect itself
from the battery when fully charged.
Storage
Smart Carts can be stored in the Smart
Cart Charging Station for long periods of
time without harming the battery. The
Smart Cart circuitry monitors the battery level, and when it
falls below a certain level, the circuitry will start charging
the unit. When the battery is fully charged, the Smart Cart
charging circuitry will stop charging the unit.
Technical Support
-
The top illustration shows four Smart Carts in position with
their USB Charge Cables attached. The fifth charger cable
is stored in the slot on top of the station. The USB Power
Cord is shown connected to the USB Port on the side of the
Charging Station.
The bottom illustration shows the storage places for the
Smart Cart Accessories.
Operation
Connect the larger end of the USB Power Cord to the USB
port on the end of the power adapter. Connect the smaller
end of the USB Power Cord to the USB Port on the side of
the Smart Cart Charging Station. Plug the power adapter
into a compatible electrical receptacle.
For assistance with any PASCO product, contact PASCO
at:
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone: 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Fax: (916) 786-7565
Web: www.pasco.com
Email: support@pasco.com
Product End of Life Disposal Instructions:
This electronic product is subject to disposal and recycling
regulations that vary by country and region. It is your
responsibility to recycle your electronic equipment per your
local environmental laws and regulations to ensure that it
will be recycled in a manner that protects human health
and the environment. To find out where you can drop off
your waste equipment for recycling, please contact your
local waste recycle/disposal service, or the place where
you purchased the product.
On the Smart Cart, push the plunger all the way into the
body of the cart before putting the cart into one of the slots
of the Charging Station. Connect the USB Charging Cable
into the USB port on the side of the Smart Cart. The battery
012-15277A
The European Union WEEE (Waste Electronic and Electri
cal Equipment) symbol (to the right) and on the product or
its packaging indicates that this product must not be dis
posed of in a standard waste container.
-
-
2
Loading...