PASCO ET-8783 User Manual
Model No. ET-8783 012-08761-A
Energy Transfer - Wind Turbine
Model No. ET-8783
Equipment List
1
ET-8771
not included
2
Included Equipment Replacement
Model Number*
1. 5-Blade Fan
2. Thumb Nut
3. Spacer (hidden from view)
550-023
614-006
615-046
*Use Replacement Model Numbers to expedite replacement orders.
Additional Equipment Required
Energy Transfer Generator
ET-8771
1
Energy Transfer - Wind Turbine Model No. ET-8783
Introduction
The Energy Transfer - Wind Turbine accessory can be attached to the
Energy Transfer Generator (ET-8771) to create a wind energy turbine.
Equipment Setup
Energy Transfer-Wind Turbine Assembly
1. Remove the thumb nut and pulley from the Energy Transfer Generator.
Do not discard these components. Retain for other use.
2. Place spacer over plastic shaft of the Energy Transfer-Generator.
3. Place 5-blade fan over same plastic shaft of Energy Transfer
Generator.
4. Note orientation of 5-blade fan. See Figure 1.
5. Secure 5-blade fan with thumbnut. Do not over tighten.
do not
discard
thumbnut
ET-8771
(not included)
spacer
5-blade fan
Figure 1: Wind Turbine Assembly
2
Loading...