PASCO ES-9079 User Manual

Instruction Sheet
for the PASCO
Model ES-9079

BASIC VARIABLE CAPACITOR

012-07169B

03/00

$1.00

Basic V ariable Capacitor

Introduction

The PASCO experimental Variable Capacitor,
ES-9079, consists of two plastic plates 18 cm in
diameter which can be adjusted to various separations.
The movable plate is mounted on a calibrated slide
which gives the plate separation directly in
centimeters. Binding posts are provided for electrical
connection to each plate. Three plastic spacers are
attached to the fixed plate so that when the movable
plate is made to touch these spacers, the plate
separation is 1 mm.

The plates need to be connected to the electrometer
by a low-capacitance cable. Keep the leads of the
cables as separated as much as possible to
minimize capacitance.

It is extremely important that the plates of the capacitor
remain parallel. It is possible that through mishandling
they will cease to be parallel and adjustment must be
made. On the back side of the moving plate are vertical
& horizontal adjusting screws. By adjusting these two

© 1999 PASCO scientific

Basic Variable Capacitor 012-07169A

screws, the two plates may be made parallel.

Keep the black plate supports clean to prevent leakage
of the charge from the plates.

Equipment

INCLUDED

• Basic Variable Capacitor (ES-9079)

• BNC cable

ADDITIONAL REQUIRED

• Basic Electrometer (ES-9078)

Limited Warranty

PASCO scientific warrants the product to be free from
defects in materials and workmanship for a period of
one year from the date of shipment to the customer.
PASCO will repair or replace, at its option, any part of
the product which is deemed to be defective in
material or workmanship. The warranty does not
cover damage to the product caused by abuse or
improper use. Determination of whether a product
failure is the result of a manufacturing defect or
improper use by the customer shall be made solely by
PASCO scientific. Responsibility for the return of
equipment for warranty repair belongs to the
customer. Equipment must be properly packed to
prevent damage and shipped postage or freight
prepaid. (Damage caused by improper packing of the
equipment for return shipment will not be covered by
the warranty.) Shipping costs for returning the
equipment after repair will be paid by PASCO
scientific.

Address: PASCO scientific

10101 Foothills Blvd.
Roseville, CA 95747-7100

Phone: [phone]

FAX: [phone]

e-mail: [e-mail]

Web site: www.pasco.com

2