PASCO EM-8642A User Manual

Instruction Sheet
for the PASCO
Model EM-8642A

INDUCTION EXPERIMENT SET

012-04758B

Introduction

The PASCO Model EM-8642A Induction Experiment Set
includes a set of three aluminum paddles, a swing and a
mounting bar which will enable you to perform demonstra­tions of induction and magnetic damping and to demonstrate
the magnetic force on a current-carrying wire.

The PASCO Model EM-8642A Induction Experiment Set is
designed to be used with the PASCO Model EM-8641
Variable Gap Lab Magnet and suggested experiments can be
found in the experiment manual that is included with the
PASCO Model EM-8641 Variable Gap Lab Magnet.

Additional Equipment Required:

• Variable Gap Lab Magnet

• Lab Stand

Additional Equipment Recommended:

• Low Voltage Power Supply such as PASCO Model PI­9593, SF-9582 or SF-9584A
or

• Mini-Generator, PASCO Model SE-8645

• Patch Cords, PASCO Model SE-9750 or SE-9751

10101 Foothills Blvd.  Roseville, CA 95678-9011 USA

®

Phone [phone]  FAX [phone]  web: www.pasco.com

better

ways to

teach science

012-04758B

Limited Warranty

PASCO scientific warrants this product to be free from
defects in materials and workmanship for a period of one
year from the date of shipment to the customer. PASCO will
repair or replace, at its option, any part of the product which
is deemed to be defective in material or workmanship. This
warranty does not cover damage to the product caused by
abuse or improper use. Determination of whether a product
failure is the result of a manufacturing defect or improper
use by the customer shall be made solely by PASCO
scientific. Responsibility for the return of equipment for
warranty repair belongs to the customer. Equipment must be
properly packed to prevent damage and shipped postage or
freight prepaid. (Damage caused by improper packing of the
equipment for return shipment will not be covered by the
warranty.) Shipping costs for returning the equipment, after
repair, will be paid by PASCO scientific.

Equipment Return

Should this product have to be returned to PASCO scien­tific, for whatever reason, notify PASCO scientific by letter
or phone BEFORE returning the product. Upon notifica­tion, the return authorization and shipping instructions will
be promptly issued.

NOTE: NO EQUIPMENT WILL BE ACCEPTED
FOR RETURN WITHOUT AN AUTHORIZA­TION.

When returning equipment for repair, the units must be
packed properly. Carriers will not accept responsibility for
damage caused by improper packing. To be certain the unit
will not be damaged in shipment, observe the following
rules:

1. The carton must be strong enough for the item shipped.

2. Make certain there is at least two inches of packing
material between any point on the apparatus and the
inside walls of the carton.

3. Make certain that the packing material can not shift in
the box, or become compressed, thus letting the instru­ment come in contact with the edge of the box.

2

®