Parts Express PB252B User Manual

Portable Rugged IPX6
Waterproof Bluetooth Speaker

User’s Manual

Introduction:

PB252B

1.ON/OFF /Play/Pause/Phone button

2. Previous/Volume –

3.Next/Volume +

4.Status LED

6.Micro USB Charging Port / AUX Input Port

Included:

1.Speaker

2.USB Micro Charging Cable

3.3.5mm Audio Cable

4. User Manual

Specifications:

Supported Profiles: A2DP, HFP, AVRCP
Bluetooth Range: 33ft (1 0m)
Dimensions: 185 mm x 25 mm x 82 mm

Begin Streaming Music

Press to start playing music
Press and Hold 2 seconds to play the next trac k
Press and Hold 2 seconds to play previous track
Press button or to set the volume level

Making and Receiving Phone Calls

When the unit is connected and paired to your device,
the unit allows you to make or receive phone calls with its
built-in microphone.
Press to accept a calll,

to
end a call press .
To reject a call, press and hold for 2 seconds

Aux-In Mode

Plug in the supplied 3.5mm to micro USB cable. The mi cro USB
connector will plug into your BT speaker, the 3.5mm connector is
for the input audio source. The Blue LED will flash slowly when in
Aux mode. Please note music selection and volume can’t be
controlled by your device in AUX mode.

Thank you for choosing the PB252B as your source for entertainment!
You can use this item with iPads, iPhones, iPods and many types of
smartphones to stream music and enjoy handsfree calling. In order to
get the best results when using the device, please read this manual
first before using.

Description:

2 1 3

5

4

6

Battery: Li-Ion 3.7V, 2000 mAh
Charging: DC 5V @ 500 mA
Weight: 320g

Operation:

Powering On

Press and Hold ON/OFF button 2 seconds to power ON, the
Blue LED will start to flash rapidly.
If an AUX (3.5 mm) cable is connected the Blue LED will slowly
blink indicating unit is in AUX-In mode.

Powering Off

Bluetooth mode: Press and hold ON/OFF button for 2
seconds to disconnect the Bluetooth, then press and hold
ON/OFF button again to power off the speaker.
AUX mode: Press and hold ON/OFF button for 2
seconds to power off.

Bluetooth Mode

Pairing
The unit will automatically go into pairing mode when it is
powered ON.
Go into your Bluetooth device settings menu and look for
PB252B.
After the unit has paired and connected, it will re-connect
automatically when the unit is powered on and the device
is in range.

*Auto power off after 10 minutes inactivity.

Charging

Attach the USB cable to the unit, and plug into any USB charger. If
the unit is completely discharged, it will take approximately 3 hours to
fully charge.
The red LED will illuminate during charging, when it has
completed, the red LED will turn off.
Note: There will be a beep when the battery is low and needs to be
recharged.

LED Status

Blue LED rapidly flashing or blue LED

solid

Bluetooth Mode

Blue LED slowly flashing

Aux Mode

Red LED solid

Charging

Troubleshooting

No sound output

Speaker needs to be connected/

re-paired to device

Tone every few seconds

Speaker needs to be charged

Will not power on

Speaker needs to be charged

Can’t control from

mobile device

Speaker needs to be in Bluetooth

mode for full control

Unit distorts at
high volume

The devices’ volume needs to

be lowered