Partilink P4K-HUL4E1, P4K-HUL4E1-P User Manual
P4K-HRSUL4E1
/
P4K-
LHRSU1E4
User manual
P4K-HUL4E1 4K UHD HDMI & USB Over IP Extender
P4K-HUL4E1-P 4K UDH HDMI & USB Over IP Extender with PoE
P4K-HRSUL4E1-P/ P4K-LHRSU1E4-P
Partilink Technology Co., Ltd Copyright @2016
Table of Contents
1. Introduction 4
2. Features & Application 5
3. Specifications 6
4. Hardware Description 7
4.1 Transmitter 7
4.2 Receiver 9
5. Installation 11
5.1 Device Connection 11
5.2 IP Configuration 15
6. Web User Interface Configuration 18
6.1 System 18
6.1.1 Version Information 18
6.1.2 Update Firmware 19
6.1.3 Utilities 21
6.1.4 Statistics 22
6.2 Video Wall 24
6.2.1 Basic Setup 24
6.2.2 Advanced Setup 30
6.3 Network 35
6.3.1 IP Setup 36
6.3.2 Casting Mode 37
6.4 Functions 38
6.4.1 IP Setup 39
6.4.2 Casting Mode 41
6.4.3 Serial over IP 42
7. Broadcast Configuration Example 44
7.1 Multicast 44
7.2 Unicast 45
7.3 Matrix 45
7.4 Video Wall 46
7.4.1 Basic Setup 46
7.4.2 Advanced Setup 47
8. Package Contents 51
1. INTRODUCTION
The 4K HDMI & USB over IP Extender is a solution for
audio, video and USB signal extension via Local Area
Network (LAN). It can be used as audio, video and
KVM extender over IP and applied to point to point,
point to multi-point, multi-point to multi-point and screen
wall broadcast system controlled by USB, RS-232, IR
and configured the 4K HDMI & USB over IP Extender
by web browser. An easy installation system built up
with Giga Ethernet switch which has IGMP function and
CATx cable for extension or broadcast. The
P4K-HUL4E1-P supports PoE (Power over Ethernet)
function.
4
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
2. FEATURES & APPLICATIONS
4K HDMI over IP extension
USB 2.0 over IP extension
RS-232 bi-directional extension
4-bit DIP switch for 16 stream channel selection
HDCP 1.4 compliant and Blu-Ray ready
Support two way IR extension
Output video rotation
Output video partial enlargement
Automatic EDID configuration
Networking environment under Giga Ethernet switch
and CATx cable
Point to point extension, unicast, multicast and
screen wall system.
Point to point extension via CAT5e cable without
Ethernet switch up to 100M
Ethernet webpage management
RS-232 Serial control command management
P4K-HUL4E1-P supports Power over Ethernet
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
5
HDMI Type
-
A female
HDMI Type
-
A female
2x 3.5mm phone jack for IR emitter and receiver to control video
Embedded webpage
OPERATING
ESD protection air gap discharge ±8KV,
3. SPECIFICATION
P4K-HUL4E1
P4K-HUL4E1-P
4K UHD HDMI
Over IP Extender
VIDEO INPUT
VIDEO OUTPUT
IR
COMPRESSION Visual lossless compression
HDMI
INPUT RESOLUTION
HDMI
OUTPUT RESOLUTION
VGA
OUTPUT RESOLUTION
AUDIO FORMAT Stereo 192Kbps
IP PROTOCOL TCP, UDP, RTSP, RTP, DHCP, IGMP, Multicast, IPV4
LAN PORT RJ45 connector for Giga Ethernet
SERIAL DB-9 male connector for RS-232 extension
MANAGEMENT
POWER INPUT 2.0mm power jack for DC12V/2A input
OPERATING TEMPERATURE
HUMIDITY
POWER SUPPLY Power adapter AC in 100~240V (50~60Hz)
ESD
DIMENSION 194 x 114 x 28 mm
WEIGHT TX 620g, RX 610g
** Product specifications are subject to change without notice.
6
P4K-HRSUL4E1
P4K-HRSUL4E1-P
Transmitter
connector
connector for loop through
VGA DB-15 female local
output
source device
3840x2160 30/24, 1080p 60/50, 1080p 30/25, 1080i 60/50
720p 60/50, 480i 60/50, 480p 60/50
3840x2160 30/24, 1080p 30/25, 1080i 60/50,720p 60/50
480i 60/50, 480p 60/50
1080p 30/25, 1080i 60/50, 720p 60/50
480i 60/50, 480p 60/50
LAN port None
management
0~55℃
5%~90% RH
contact discharged ±4KV
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
P4K- LHRSU1E4
P4K-LHRSU1E4-P
Receiver
None
HDMI Type-A female connector
HDMI Type-A female connector
4. HARDWARE DESCRIPTION
4.1 Transmitter
P4K-HUL4E1/ 4K-HUL4E1-P (TX)
1. 12 VDC power supply with locking for 4K HDMI &
USB over IP Extender.
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
7
2. RCA connector for stereo audio output.
3. RCA connector for stereo audio input.
4. HDMI video input connector
5. 10/100/1000 Mbps self-adaptive Ethernet interface.
6. ACT LED indicator turns green when 4K HDMI &
USB over IP Extender is powered up.
7. LINK LED indicator flickers green when network
connection is waiting for video source, turns green
when network connection and video source is
functioning properly
8. DB9 connector for RS-232 remote extension
9. Connect IR extension cable to IR port and position
the emitters near the devices you want to control
10. PC USB port for remote additional device such as
USB mouse, USB keyboard and USB pen drive
connecting to PC
11. Group configuration, 4-bit DIP switch to set up the
group ID
12. Restart the 4K HDMI & USB over IP extension by
pressing RESET button
13. Press EDID button for manual EDID copy function
14. DB9 connector for VGA local display
8
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
4.2 Receiver
P4K-LHRSU1E4/ P4K-LHRSU1E4-P (RX)
1. 12 VDC power supply with locking for 4K HDMI &
USB over IP Extender.
2. RCA connector for stereo audio output.
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
9
3. RCA connector for stereo audio input.
4. HDMI video input connector
5. 10/100/1000 Mbps self-adaptive Ethernet interface.
6. ACT LED indicator turns green when 4K HDMI &
USB over IP Extender is powered up.
7. LINK LED indicator flickers green when network
connection is waiting for video source, turns green
when network connection and video source is
functioning properly
8. DB9 connector for RS-232 remote extension
9. Connect IR extension cable to IR port and position
the emitters near the devices you want to control
10. Group configuration, 4-bit DIP switch to set up the
group ID
11. Restart the 4K HDMI & USB over IP extension by
pressing RESET button
12. Press EDID button for manual EDID copy function
13. 4 USB ports for additional USB devices such as
USB mouse, USB keyboard and USB pen drive.
10
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
Group Setting via 4-bit DIP switch
Setting the Transmitter and Receiver group ID via the 4-bit DIP
switch. The correspondent receivers are required to switch to
the same ID as the receiver. It can set up maximum 16 Group
IDs. Reboot the system to apply the group setting.
TX
RX
5. INSTALLATION
5.1 Device Connection
1. Check the power supply is unplugged.
2. Set up the group of the transmitter with the
correspondent receiver for signal extension and
display.
3. Connect the Transmitter to video source with HDMI
cable, and connect Receiver to a monitor or display
with HDMI cable.
4. Connect the USB cables from Transmitter to PC,
and connect the USB additional devices such as
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
11
USB mouse, USB keyboard and USB pen drive to
Receiver.
5. Connect Transmitter and Receiver to the Ethernet
switch with network cable.
6. Power on the Transmitter, Receiver and all the
connected devices.
7. Power on and activate all the connected devices.
8. Connect the IR extension cable with Transmitter
and the IR receiver cable with Receiver for remote
control.
◆ Configuration
12
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
◆ Application Pattern
■ Unicast
■ Multicast
a. Video Distribution
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
13
b. Matrix Distribution
c. Billboard & Kiosk, PC to HDMI and USB
Interactive Monitor
14
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
■ Screen Wall
5.2 IP Configuration
The 4K HDMI & USB Over IP Extender can configure
via LAN in the same subnet.
1. Assign a LAN IP address to the computer in the
same subnet. The IP address default of the
Transmitter and Receiver is B class Networking:
169.254.xxx.xxx.
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
15
Figure 1. Internet Protocol (TCP/IP) Properties
2. Connect all devices with proper cables except
video source, please refer to Figure 2
Figure 2. Demonstrate the 4K HDMI & USB Over IP Extender
16
Partil ink Technolog y Co., Ltd Copyr ight @ 2016
Loading...