Parksafe Automotive Silent Witness SW004, Silent Witness SW008 Quick Setup Manual

SW004/8 AHD DVR QUICK SET UP GUIDE

SW004 AHD 4 CHANNEL DVR

SW008 AHD 8 CHANNEL DVR

Following installation, we advise that the following settings are checked

and adjusted to suit the required configuration.

Note: Following screen display may alter slightly by firmware version.

Step 1.

Using the supplied remote control,

press “MENU”.

Admin is the account used to change system settings.

The screen to the left is displayed, using the directional

keys, move the cursor to “OK” and press “ENTER”.

Note: Password will be automatically entered

Step 2.

Press “MENU” again, now highlight “MENU”, and press

“ENTER”.

Step 3.

This is the Main Menu, from here you can

navigate to the different device settings.

You can return here at any time, by repeatedly

pressing the “return”

button on the remote.

Step 4. Vehicle Info.

Path: Menu - Basic - VehiInfo

Here you can set basic vehicle details.

When complete, highlight “OK” and press enter.

Step 5. Time / Date

Path: Basic - DateTime

Ensure that the correct settings are entered for

your region, the time and date can be

synchronised from satellite via G.P.S.

When complete, highlight “OK” and press enter.

Step 6. On/Off Settings

Path: Menu - Basic - On/Off - CTRL

Here, the parameters for when the device will switch

on/off can be adjusted.

Ignore – Device will ignore vehicle ignition setting.
Delay – Time to remain on after ignition off.
Timing – Timed on/off programs (24 hr clock)

When complete, highlight “OK” and press enter.

Step 7. On/Off Settings

Path: Menu - Basic - On/Off - VOLT

The device will detect the vehicle voltage automatically, when the

battery voltage is lower than the Shut.Volt, the device will shut

down, to avoid draining the battery. When the voltage is higher than

the PowerVolt, the device will power on, and begin recording.

Powertype – Please set this to AUTO

Shut Volt – Voltage when device will power off.

Power Volt – Voltage when device will power on.

When complete, highlight “OK” and press enter.

Step 8. Camera Type

Path: Menu - Record - Mode

Select PAL or NTSC to suit camera type.

Each camera fitted must be marked valid/enable.

Camera types (960H/720P) are set in pairs.

When complete, highlight “OK” and press enter.