Park Play HR-704 Owner's Manual

!

HR-704 Bluetooth Speaker Owner’s guide

l Controls

l In the box

1 x HR-704 Bluetooth speaker 1 x Micro USB charge cable

1 x Users manual 1 x AUX cable

Volume-/back!

Volume+/next!
Power !

Bluetooth!

Play/Pause/Hands-free

USB charge!

Reset!

AUX in!

!

l Waterproof features

The HR-704 is IPX5 waterproof. Water projected by a nozzle (6.3 mm) against enclosure from
any direction shall have no harmful effects.

l Charging the HR-704 (3.7V rechargeable battery built-in)

1- Connect HR-704 to PC/Laptop/Mac or any 5V USB adapter (not included) via the USB cable

included.
2- Red LED turns ON during charging, turns OFF after fully charged.
3- Unplug USB cable after fully charged.
4- Red LED twinkles when low power (<21%), with voice talk “Battery Level Low” every 30

seconds.
5- Speaker turns off automatically in 5 minutes if no pairing action.

l Pairing with Bluetooth enabled devices (Mobile phones/Tablets etc.)

1. Keep the speaker and device within 1 meter of each other.

2. Hold the power button for 2 seconds to turn the speaker on, the LED of all buttons turns on in

solid blue.

3. LED of Bluetooth/Hand-free will blink quickly in blue with voice talk “Bluetooth Mode”, while

the speaker enters search mode.

4. Start the Bluetooth function on your mobile device and look for “HR-704” in the Bluetooth

device list (depending on the Bluetooth version of your device you may have to enter pass

code ‘0000’).

5. After successfully connecting, the LED will change to solid blue, with voice talk “Bluetooth

paired”.

Note:

• If the pairing was not successful, turn off the speaker and re-pair again.

• After successful pairing, paired devices will remember each other so there is no need to pair

again unless pairing information is deleted.

• To pair with a new device, just follow steps 1-5 above after disconnect with existing device.

• In case the buttons not operate properly, press the Reset button located beside USB port by

needle or other sharp stuff.