This unit is the HE40 model, an
outdoor gas heater which is
suspended the ceiling. This is the only
Australian manufactured electronically
operated patio heater in Australia and
can be turned on or off at the flick of a
conveniently located switch... which
means no more climbing ladders to
light your heater.
Patio Heater Instructions
OZGLOW HE 40 Hi/Lo
All of our heaters come with a 12-month domestic or 90-day commercial
limited warranty, and are fully serviceable with readily available parts if
required. Delivery is available throughout Australia and overseas.
The suspended gas heater; model HE40 will heat the patio while
leaving the floor free of obstruction.
This unit features:
• 40 MJ/h input gas rate for Natural Gas, and 42 MJ/h for Propane Gas
This heater must be installed to the requirements of the
local authorities both gas and electrical. The installation
must comply with the gas installation code AG 601.
The fitting of the transformer and wiring to the appliance
must comply with the national wiring code and must be
performed by a licensed electrician.
Each heater must be fitted with its own high/low switch
and this switch must be isolated from all other sources
of electricity. If this is not done a hazardous situation
could occur. If more than 1 heater is wired to the
same high/low switch the warranty is void.
The OZGLOW HE 40 Hi / Lo patio heater is available in
versions for use with either Natural or Propane Gas. Gas
pressure details and gas type are on the appliance data
plate.
This appliance is certified for outdoor use in both
residential and non-residential premises.
This appliance is also certified for nonresidential indoor use. When used indoors, the
minimum room size is 200m3.
This appliance must only be used in a well ventilated area.
Do not place articles on or against this appliance.
Do not use or store flammable materials near this
appliance.
Do not spray aerosols in the vicinity of this
appliance while it is in operation.