Use removal tool made for existing nozzle to remove one nozzle
at a time by rotation 1/4 turn
counter clockwise to unlock.
The system is hydraulically balanced, so the same size nozzle
needs to go back into the appropriate hole.
Use removal tool made for existing nozzle to remove one nozzle
at a time by rotation 1/4 turn
counter clockwise to unlock.
The system is hydraulically balanced, so the same size nozzle
needs to go back into the appropriate hole.
Check the size of the opening
on the existing nozzle and then
select the closest RetroJet cap
from the pack of three provided in the replacement kit.
Check the size of the opening
on the existing nozzle and then
select the closest RetroJet cap
from the pack of three provided in the replacement kit.
UNIVER SAL IN-FLOOR NOZZLE REPLACE MENTS
TM
UNIVER SAL IN-FLOOR NOZZLE REPLACE MENTS
TM
This installation guide walks you
through the steps involved in removing an existing cleaning nozzle
and properly installing a new Retrojet.
For technical assistance call
1.800.621.5886 or contact your
regional representative
This installation guide walks you
through the steps involved in removing an existing cleaning nozzle
and properly installing a new Retrojet.
For technical assistance call
1.800.621.5886 or contact your
regional representative
For replacing: A&A Quikclean1, A&A Quikclean2, A&A Quikclean Gamma 3,
Caretaker 99, Caretaker 99 Threaded, Net’N’Clean and Pool Valet
For replacing: A&A Quikclean1, A&A Quikclean2, A&A Quikclean Gamma 3,
Caretaker 99, Caretaker 99 Threaded, Net’N’Clean and Pool Valet
1 1
2 2
RETROJET
INSTALLATION GUIDE
RETROJET
INSTALLATION GUIDE
www.1Paramount.com 1.800.621.5886 www.1Paramount.com 1.800.621.5886
Place the selected cap over the
the top of the RetroJet nozzle
and press firmly against a hard
surface. You will hear a snap
when the pieces have properly
locked together.
Place the selected cap over the
the top of the RetroJet nozzle
and press firmly against a hard
surface. You will hear a snap
when the pieces have properly
locked together.
Press the top of the complete
RetroJet nozzle onto the three
prongs of the RetroJet installation tool*. Guide the nozzle into
the hole in the pool floor and
then rotate clockwise 1/4 turn
to lock in place.
Press the top of the complete
RetroJet nozzle onto the three
prongs of the RetroJet installation tool*. Guide the nozzle into
the hole in the pool floor and
then rotate clockwise 1/4 turn
to lock in place.
Allow the nozzle to cycle
through the cleaning process
to ensure that it was installed
properly.
Allow the nozzle to cycle
through the cleaning process
to ensure that it was installed
properly.
3 3
4 4
5 5
www.1Paramount.com 1.800.621.5886 www.1Paramount.com 1.800.621.5886
004-027-8783-00 REV033010004-027-8783-00 REV033010
Loading...