ParaBody 843102 User Manual
I I I I
843102 POWER RACK
ASSEMBLY INSTRUCTIONS
Part # 6757501
III I II I II II
1 Revision: 5/06/98
I
] ,Ily~, ORTANT NOTES
!
W~LCOM~ TO WOP.LD OF $’eKm~~ $’ted./
Please note:
* Thank you for purchasing the Parabody 843102 POWER RACK. Please read these instruc-
tions thoroughly and keep them for future reference. This product must be assembled on’a fiat,
level surface to assure its proper function.
* We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your Parabody customer service representative
at (800) 328-9714.
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
1. Inspect equipment daily. Tighten all loose connections and replace woru parts immediately.
Failure to do so may result in serious injury.
Do not allow minors or children to play on or around this equipment.
2.
3. Exercise with care to avoid injury.
4. If unsure of proper use of equipment, call your local Parabody distributor or call the
Parabody customer service department at (800) 328-9714.
5. Consult a physician before beginning any exercise program.
Tools Required for Assembly
* 3/4" wrench
* Ratchet with 3/4" and 9/16" sockets
* Rubber Mallet or Hammer
......... Bolt’ ~
NOTE: BOLT LENGTH IS 1V[EASURED FROM THE UNDERSIDE OF TFI-E HEAD OF THE BOLT.
Length Ruler
BOLT LENGTH RULER:
0[ 1
BOLT LENGTH
1/2 I 1/2 I 1/2 I 1/2 1 1/2 " I
2 3 4 5 6
PARTS LIST
PART# DESCRIPTION
6641503
6641802
6605702
6605802
6605902
6606002
6606102
3102910
’ ’LOWER CONNECTOR
UPRIGHT
SA~T~L
BAR sUPPORT
CHIN BAR
UPPER CON~CTOR " ’
1/2X3"BOLr
QTY
2 9
2
2 12
1 15
KEY
PART# DESCRIPTION
3102917 ’ i/2~4"BOLT
3102502
3102801
6606801
6405201
6467001
6590801 " ’ 3 X 2" INSERT GUIDE
1/2" WASHER
I~’iLOCKNUT
SPRING PIN ASSEMBLY
’ 2"SQ. ENDCAP
2" SQ. COVER CAP
QTY
4
20
-14
6
’4
4
FIGURE 1
STEP 1:
¯ Slide four 2" SQ. COVER CAPS (14) over the ends of each UPRIGHT BASE (2) as shown in F]:GURE
¯
LOOSELY assemble the LOWER CONNECTOR (6) between each UPRIGHT BASE (2) using four 1/2 X 3" BOLTS (8), four
WASHERS (10), and four 1/2" LOCK NUTS ( l 1). See FIGURE
3
Loading...