ParaBody 813102 User Manual

Serious
813102 VKR/CHIN/DIP
Part# 6812201
ASSEMBLY INSTRUCTIONS
Revision: 01/17/00
[IMPORTANT NOTES]
Please note:
*
Thank you for purchasing the Parabody 813102 VKRJCHIN/DIP. Please read these
instructions thoroughly and keep them for future reference. This product must be assembled
¯ on a flat, level surface toassure its proper function..
* We recommendcleaning your product (pads and frame) oI~ a regular basis, using warm soapy
water. Touch-up paint can be purchased from your Parabody customer service representative
at (800) 328-9714.
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
1. Inspect equipment daily. Tighten all loose connections and. replace worn parts immediately. Failure to do so may result in serious injury.
Do not allow minors or children to play on or around this equipment.
2.
3.
Exercise with care to avoid injury.
4. If unsure of proper use of equipment, call your local Parabody distributor or call the Parabody customer service department at (800) 328-9714.
! Tools Required for Assembly]
* 9/16" wrench * Ratchet with 9/16" socket
* Adjustable wrench * Hammer
* Tape measure
Bolt Length Ruler I
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSI~E OF THE HEAD OF THE BOLT.
BOLT LENGTH RULER:
0
1
BOLT LENGTH
2
I , I I
3 4
I [ I ,
5
6
PART#
1
6102303 2 6480003 " 3
6480503
4 6480903
¯ 5 6665902
6
6752702
7 310250 1
8
3102601
DESCRIPTION
BASE CONNECTOR
CHINBAR
: ......
VKRSIDE
UPPERBACK SUPPORT
- BACKPAD ARM PAD
3/8" FLAT WASHER
3/8" LOCK WASHER
2 1 10
2
1
2
34
6
PART#
9 3102802
3102904
11 3103101
12
3103103
"13
14
15
6236701
6405201 6467001
DESCR1FHON
3/8" LOCK NUT
3/8 X 3" BOLT
1-1/4X5" GRIP 1-1/4X7’ ChTdP
1-3/4" SQ. END CAP
2" SQ. END CAP
2" SQ. COVER CAP
14
20
2
6
1
4
4
FIGURE 1
STEP 1:
¯ Insert four 2" SQ. COVER CAPS (15) into the ends of the VKR SIDES (3) as shown in FIGURE ¯ Insert four 2" SQ. END CAPS (14) into the the ends of the VKR SIDES (3) as shown in FIGURE
3
Loading...
+ 5 hidden pages