Panthers Report H6240 User Manual

Introduction

The Model H6240 Hydraulic Table Cart (Figure 1)
will move and raise material weighing up to 600
lbs. to a maximum comfortable working height of
291⁄4" above the floor.

The Model H6240 was carefully packed when it
left our warehouse. If you discover this hydrau
lic table cart is damaged after you have signed
for delivery, please immediately call Customer

Service at [phone]

Save the containers and all packing materials for
possible inspection by the carrier or its agent.

Otherwise, filing a freight claim can be difficult.

for advice.

Hydraulic Table Cart

MODEL H6240

-

Figure 1. 600 lb. Capacity hydraulic table cart.

When you are completely satisfied with the condi
tion of your shipment, you should inventory the
contents.

Figure 2 -

A. Cart (Not Shown) ....................................... 1

B. Handle ........................................................ 1

C. Foot Pedal .................................................. 1

D. Hex Bolts M8-1.25 x 40 .............................. 2

E. Hex Bolts M8-1.25 x 20 .............................. 1

This table cart is not a toy. DO NOT allow
children to use this cart. Serious injury may
occur if this cart is used incorrectly.

Inventory.

-

B

C

Figure 2. Inventory.

D

E

ASSEMBLY

1. Slide the lifting pedal into the pedal shaft,

and insert the M8-1.25 x 20 hex bolt through
the hole in the side of the pedal shaft and into
the lifting pedal (Figure 3

2. Place the handle in the handle sockets and
secure with the M8-1.25 x 40 hex bolts
(Figure 3).

).

Lifting Pedal

OPERATIONS

Keep hands out of the scis­sor lift to prevent serious
crushing injuries

1. Balance the load evenly in the center of the

cart.

2. Pump the lifting pedal to raise the table.

3. Push the pressure release pedal to lower the

table. Note—Always lower the table when
not in use.

.

MAINTENANCE

Handle

Figure 3. Assembly.

Failure to follow these instructions will
result in serious personal injury:

1. Keep hands out of the scissor lift to prevent

serious pinching and crushing injuries.

2. DO NOT exceed the 600 lb. load capacity.

3. Lock the rear casters when loading and

unloading the cart.

4. Balance the load evenly in the center of the
cart.

5. Transport the load in the fully lowered posi­tion to prevent tipping.

Lifting Pedal

Hex Bolt

1. Fully lower the tabletop when not in use.

2. Wipe all dirt and dust off the table cart.

3. Apply light oil to the surface of the hydraulic

jack ram.

4. Remove the plug on the top of the hydraulic
jack to check the oil level. Add oil if neces
sary, replace the plug, then pump the handle
several times with the pressure release valve
open to bleed the air out of the system.

If you need additional help with this procedure,
call our service department at: [phone].

-