Specifications are subject to change. Please check the rating label on the back of the machine.
Installation
The installation of the unit must only be performed by a qualified technician.
Confirm that the device is positioned on a solid, even, safe and stable surface that tolerates
the weight of the unit.
Ensure no flammable products are placed near the unit.
Position the device appropriately so that the plug is always accessible.
Check the unit isn’t placed close to any water or any corrosive gas.
Please Note: this section applies to all products featured in this manual
Operating Instructions
IND340
Operational Program
Be sure to follow the instructions below:
Place suitable cookware onto the plate of the induction hob (see section below for a list of
suitable pans), and connect the plug to a suitable socket.
After connecting, the power light will illuminate, indicating that the power is connected
correctly.
Press the ON/OFF button and the display will illuminate, indicating that the induction unit is
heating up. The default power is 2000W. Adjust the power rate from 500-2900W by pressing
“+”or “-”
Press the FUNCTION button and the temperature setting will show on the display, indicating
that temperature adjustment is being controlled. The default temperature is 120℃. Adjust
the temperature from 60℃ to 240℃ by pressing “+”or “-”.
Press the TIMER button to adjust the time from 0 minute to 180 minutes by then pressing
“+”or “-”.
When pressing the ON/OFF button during the working state, the induction unit will stop
working immediately. After stopping working, the fan will cool the induction cooker for one
minute, and then it will be completely switched off.
After pressing the ON/OFF button to switch the unit on, the induction cooker will shut off
automatically if there is no operation within 2 hours.
After you select a function, press the LOCK button for 1 second to lock the function that you
want, then the LOCK indicator will be shown on the display. The induction cooker will have
no response when pressing any other button during this LOCK state. If you want to select
another function or want to stop using the unit, press the LOCK button again for 3 seconds,
until it the unit makes a sound, then all the buttons will be work normally.
Warning: The outside of the appliance gets very hot during use. Do not touch.