MMSZ5221BS thru MMSZ5259BS
SURFACE MOUNT SILICON ZENER DIODES
VOL TAGE
2.4 - 39 V olts
POWER
200 mWatts
FEATURES
• Planar Die construction
• 200mW Power Dissipation
• Zener Voltages from 2.4V - 39V
• Ideally Suited for Automated Assembly Processes
MECHANICAL DATA
Case: SOD-323, Plastic
Terminals: Solderable per MIL-STD-202, Method 208
Approx. Weight: 0.008 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
retemaraP lobmyS
O
52ta)AsetoN(noitapissiDrewoP
C
flahelgnissm3.8,tnerruCegruSdrawroFkaeP
)BsetoN()dohtemCEDEJ(daoldetarnodesopmirepusevaw-enis
egnaRerutarepmeTegarotSdnanoitcnuJgnitarepO
P
I
FSM
D
T
J
P ACKAGE SOD-323
eulaV stinU
002 Wm
0.2spmA
051+ot55-
O
C
NOTES:
A. Mounted on 5.0mm2(.013mm thick) land area s.
B. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maxi mum.
Part Number: MMSZ5221BS thru MMSZ5259BS PAGE 1
MMSZ5221BS thru MMSZ5259BS
ELECTRICAL CHARACTERISTICS (TA=25OC unless otherwise noted) VF=1.2V max, IF=100mA for all types.
egatloVreneZlanimoN ecnadepmIreneZ.xaM
rebmuNtraP
VZ@I
ZT
V.moN V.niM V.xaM ΩΩΩΩΩ Am ΩΩΩΩΩ Am
ZZT@I
ZT
ZZK@I
ZK
IR@V
µA
esreveRxaM
tnerruCegakaeL
R
V
sedoiDreneZsttaWm002
SB1225ZSMM4.282.225.20302002152.00011 323-DOS
SB2225ZSMM 5.2 83.2 36.2 03 02 0521 52.0 001 1 323-DOS
SB3225ZSMM7.275.248.20302003152.0571 323-DOS
SB5225ZSMM 3 58.2 51.3 03 02 0061 52.0 05 1 323-DOS
SB6225ZSMM3.341.374.38202006152.0521 323-DOS
SB7225ZSMM 6.3 24.3 87.3 42 02 0071 52.0 51 1 323-DOS
SB8225ZSMM9.317.31.43202009152.0011 323-DOS
SB9225ZSMM 3.4 90.4 25.4 22 02 0002 52.0 5 1 323-DOS
SB0325ZSMM7.474.449.49102009152.052 323-DOS
SB1325ZSMM 1.5 58.4 63.5 71 02 0061 52.0 5 2 323-DOS
SB2325ZSMM6.523.588.51102006152.053 323-DOS
SB4325ZSMM 2.6 98.5 15.6 7 02 0001 52.0 5 4 323-DOS
SB5325ZSMM8.664.641.750205752.035 323-DOS
SB6325ZSMM 5.7 31.7 88.7 6 02 005 52.0 3 6 323-DOS
SB7325ZSMM2.897.716.880200552.036 323-DOS
SB9325ZSMM 1.9 56.8 65.9 01 02 006 52.0 3 5.6 323-DOS
SB0425ZSMM015.95.01710200652.038 323-DOS
SB1425ZSMM 11 54.01 55.11 22 02 006 52.0 3 4.8 323-DOS
SB2425ZSMM214.116.21030200652.021.9323-DOS
SB3425ZSMM 31 53.21 56.31 31 5.9 006 52.0 1 9.9 323-DOS
SB5425ZSMM5152.4157.51615.800652.05.011323-DOS
SB6425ZSMM 61 2.51 8.61 71 8.7 006 52.0 1.0 21 323-DOS
SB8425ZSMM811.719.81127 00652.01.041323-DOS
SB0525ZSMM 02 91 12 52 2.6 006 52.0 1.0 51 323-DOS
SB1525ZSMM229.021.32926.500652.01.071323-DOS
SB2525ZSMM 42 8.22 2.52 33 2.5 006 52.0 1.0 81 323-DOS
SB4525ZSMM7256.5253.82145 00652.01.012323-DOS
SB5525ZSMM 82 6.62 4.92 44 5.4 006 52.0 1.0 12 323-DOS
SB6525ZSMM035.825.13942.400652.01.032323-DOS
SB7525ZSMM 33 53.13 56.43 85 8.3 007 52.0 1.0 52 323-DOS
SB8525ZSMM632.438.73074.300752.01.072323-DOS
SB9525ZSMM 93 50.73 59.04 08 2.3 008 52.0 1.0 03 323-DOS
egakcaP
NOTE:
1.Tolera nce and T ype Number Designation. The type numbers listed have a standard tolera nce on the nominal zener voltage of ±5%.
2.Specials Available Include:
A. Nominal zener voltages between the voltages shown a nd tighter voltage tolerances.
B. Matched sets.
3.Zener Voltage (VZ) Measurement. Guara ntees the zener voltage when mea sured at 90 seconds while maintaining the lead temperature (TL) at 30OC, from the diode body.
4.Zener Impedance (ZZ) Derivation. The zener impedance is derived from the 60 cycle ac voltage, which results when an AC current having an rms value equal to 10% of the dc zener
current (IZT or IZK) is superimposed on IZT or IZK.
5.Surge Current (IR) Non-Repetitive. The rating listed in the electrical characteristics table is maximum peak, non-repetitive, reverse surge current of 1/2 square wave or equivalent sine
wave pulse of 1/120 second duration superimposed on the test current, IZT, per JEDEC registration; however, a ctual device ca pability is a s described in Figure 5.
Part Number: MMSZ5221BS thru MMSZ5259BS PAGE 2