Page 1
© Panduit Corp. 2007
PATCHRUNNER & NETRUNNER End Panels
Part Numbers: PREP, PREP96, WMPV45EP, WMPVHC45EP
INSTRUCTIONS CM280C
PATCHRUNNER Installation Instructions
PREP, PREP96
(1) End Panel
(6) Plastic Binding Screws
and Barrels
Assembly:
Step 1:
Insert binding Screw Barrel
into appropriate hole location
Door Bracket Lip
Retention Hook
End Panel
PREP
Location 1
Plastic Binding
Screw and Barrel
Location 2
Step2:
Place End Panel Retention
Hook over Door Bracket
Lip.
Step 3:
Align barrel holes with End
Panel mounting ho les
Step 4:
Fasten Binding Screws
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Location 3
Geometry modi fied for clarification: Not
all molded fingers are shown
Page 1 of 2
Page 2
WMPVHC45EP,WMPV45EP
(2) Endpanels
(4).375-16 Acorn nuts
(4).375 -16 Bolts
INSTRUCTIONS CM280C
NETRUNNER Installation Instructions
Note: Install lower end panel first when
using a stacked configuration.
Mounting Locations
Assembly:
Step 1:
Insert bolt into mounting
location one.
Step2:
Place End Panel over the
bolt and hand tighten nut.
Step 3:
Insert bolt into location two
a secure with acorn nut.
Tighten acorn nut in location one.
Step 4:
Repeat steps 1-3 for upper
end panel
End Panel
WMPVHC45EP (Shown)
Geometry modified for clarification: Not
all molded fingers are shown
For instuctions in Local Language s
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
cs@panduit.com
Fax:
(708)444-6448
Loading...