Page 1
© Panduit Corp. 2003
WMP1E (shown)
P
ATCHLINK
Cable Management Horizon tal Panels
Part Numbers: WMP1E, WMPF1E,WMPFSE, WMPH2E, WMPHF2E, WMPLFSE,
WMPLSE, WMPSE
INSTRUCTIONS CM282C
19” Rack
WMP1E
WMPF1E
WMPFSE
WMPH2E
Install the managers to the rack with the #12-24x.5 or M6 screws provided. Built-in
screw retention in mounting holes secures screws in manager during installation.
WMPHF2E
WMPLFSE
WMPLSE
WMPSE
Flange
Cover
Screws
The hinged cover opens from the top or the
bottom. Pull flange to open and close cover.
Install the covers to the manager by positioning cover flat against the front of the
manager fingers, then push to snap in place.
Note: The recommended assembly torque shall be 9+/-1 in-lb for #12-24 screws,
1+/-0.1 N-m for M6 screws.
The PatchLink cable manager is recommended for use with Panduit 24 or 48 port patch panels mounted above and below the manager.
When routing the cables for the patch panels, either of the following two methods are recommended to help maintain cable bend radius.
METHOD 1:For each row of 24 ports, place two cables in each slot on the manager.
Route half the cables through each of the wire retainers on the ends of the manager.
METHOD 2: If the cables are coming from one side of the rack, place 2 cables in each of the slots on the manager.
NOTE: When using front and back WMPH’stomanagecableson the rear of the rack, place2 cables in each of the 12 slotsinthe rear of
the manager, for each row of 24 ports.
METHOD 1
Wire
Retainer
METHOD 2
For Worl dwide Subsidiaries
and Sales Offices visit
Web Site: ww w.panduit.com
Finger
Finger
Wire
Retainer
Pag e 1 of 1
Part Number
WMP1E
WMPF1E
WMPH2E
WMPHF2E
WMPSE
WMPFSE
WMPLSE
WMPLFSE
Method 1
Method 2
Method 1
Method 2
Method 1
Method 2
Cable Capacity
UTP Cable
.187 dia.
96 72 312
72
48 32
24
32
16
Technical Support Phone: 866-405-6654
Fax: 708-444-6993
E-mail: ncginfo@panduit.com
SeTP Cable
.250 dia.
48
16 72
24
12
3mm dia.
Fiber
192
144
96
48
Loading...