Page 1
TJF “T” Junction
Harness Board Accessory
© Panduit Corp. 2013
INSTALLATION INSTRUCTIONS PR143N-TJF
ASSEMBLY
ASSEMBLY IS REQUIRED BEFORE
INSTALLATION
By hand, push nail into top of housing
(as shown below).
NAIL
TOP
HOUSING
TO INSTALL HARNESS
INSTALLATION
Using a
minimum
thickness of 5/8'', hammer assembly
onto harness board until the top of the
nail is even with the top of the housing.
5/8''
IMPORTANT: AFTER INSTALLATION,WHEN FIXTURE
IS NOT IN USE, KEEP IN THE ‘UP’ POSITION
harness board
USE
For instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
1. Slide housing up the nail until it stops
2. Route wires around top of the housing to
form a “T” junction
TO REMOVE HARNESS
1. Slide housing down the nail while pulling off harness
2. Install cable ties at points “A” and “B”
E-mail:
techsupport@panduit.com
www.panduit.com
Phone:
866-405-6654
Rev. 01Page 1 of 1
Loading...