Page 1
NET-A
CCESS
N-Type and S-Type Top of Cabinet
Divider Wall
INSTRUCTIONS V00029AK
© Panduit Corp. 2013
(SN7TCDW, SN8TCDW
Top of Cabinet Divider Wall - Screw Installation
• Pre-assemble screws and square nuts to divider wall
•
DO NOT completely tighten screws
- INSTALL [4] M6 Torx Screws
(use T25 Torx bit)
)
- INSTALL [4] M6 Square Nuts
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
INSTRUCTIONS V00029AK
Top of Cabinet Divider Wall - Installation
• Position [2] square nuts of Top of Cabinet Divider Wall above [2] square cutouts of Top of Cabinet Cable Manager
• Insert [2] square nuts into square cutouts of Top of Cabinet Cable Manager
• Slide Top of Cabinet Divider Wall along slot until other set of [2] square nuts is above square cutouts
• Insert remaining set of [2] square nuts into square cutouts
• Slide Top of Cabinet Divider Wall to desired position and tighten screws
- TIGHTEN [4] M6 Torx Screws
(use T25 Torx bit)
- INSERT M6 Square Nuts into
Square Cutouts
Slide Top of Cabinet
Divider Wall to
desired position
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone: 866-405-6654
Loading...