Page 1
Swing Handle Lock
for N-Type and S-Type cabinets
Part Number(s) : SDLOCK-XXX
© Panduit Corp. 2018
Swing Handle Lock
Qty: 1
INSTALLATION INSTRUCTIONS
Swing Handle Lock Key
Qty: 2
V00029PV
Tool List:
• 10mm Hex Driver
Cam
Stop
Cam
Cam Screw
Swing
Handle
Door Handle
Backing Plate
S-Type Single Hinge Door
Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench), Cam Stop (note orientation of Cam Stop), and Cam from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle (use 10mm socket wrench)
• Install Cam, Cam Stop, and Cam Screw (use 10mm socket wrench)
• When replacing Cam Stop, ensure that the orientation is the same as when it was removed.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2018
DoorRodsmustt
behind Door Rod Guides
INSTALLATION INSTRUCTIONS
V00029PV
Cam
Stop
Door Rod
Assembly
(see note)
Cam Screw
Swing
Handle
Door Handle
Backing Plate
N-Type Single Hinge Door; N-Type & S-Type Solid Rear Door
Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench) and Cam Stop (note orientation of Cam Stop) from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle with (use 10mm socket wrench)
• Install Cam Stop and Cam Screw (use 10mm socket wrench)
• Note orientation of Cam Stop
• Ensure that square cutout of Door Rod Assembly sits securely on Swing Handle
• Ensure that door rods are behind door rod guides
Note: Door Rod Assembly does not have to be disassembled. Can be manuvered out of way to install lock.
Cam
Stop
Cam Screw
Door Rod
Assembly
(see note)
Swing
Handle
Door Handle
Backing Plate
N-Type and S-Type Split Door
Combination Lock Swing Handle Replacement
• Remove Cam Screw (use 10mm socket wrench) and Cam Stop (note orientation of Cam Stop) from existing handle
• Remove Door Handle Backing Plate and remove existing door handle (use 10mm socket wrench)
• Install Swing Handle by securing Door Handle Backing Plate to Swing Handle (use 10mm socket wrench)
• Install Cam Stop and Cam Screw (use 10mm socket wrench)
• Note orientation of Cam Stop
• Ensure that square cutout of Door Rod Assembly sits securely on Lock Swing Handle
Note: Door Rod Assembly does not have to be disassembled. Can be manuvered out of way to install lock.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...