Page 1
NET-A
(Part Numbers - S2BRK6, S2BRK12, S1DR, S2DR, S1LR, S2LR
© Panduit Corp. 2013
CCESS
INSTRUCTIONS CM615C
S-Type Cable Management Panel
Cable Management Panel (S2BRK6, S2BRK12) Installation
• Center Cable Management Panel vertically on outside of cabinet post at desired location (flat
surface of bracket to face inwards)
• Fasten Cable Management Panel to cabinet by passing M5 Torx screws [
6 screws for S2BRK12] through holes of cabinet post into center holes of bracket as shown
below
4 screws for S2BRK6;
)
Cable Management Panel
DETAIL VIEW
M5 Torx Screws
-Use T25 Torx driver
Primary Mounting Hole
Alternate Mounting Holes
NOTE: Alternate mounting holes are to
be used when installing 70”+ POUs
on S2BRK6 and S2BRK12 in
42 RU cabinets
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 2
INSTRUCTIONS CM615C
D-Ring (S1DR, S2DR) and L-Retainer (S1LR, S2LR) Installation
• Cable Management D-Rings - Insert mounting tab(s) of L-Retainer into round keyhole slot(s) located on the cable management
panel. Slide D-Ring in keyhole slot to engage D-Ring.
• Cable Management L-Retainers - Insert mounting tab of L-Retainer into any keyed mounting slot located on the cable management panel. Slide L-Retainer up or down in keyed slot and engage release tab in adjacent cutout. Pull release tab and reverse the
process to remove L-Retainer.
D-RING INSTALLATION
S1DR S2DR
L-RETAINER INSTALLATION
Ensure Release Tab is
engaged in adjacent
cutout
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...