Page 1
© Panduit Corp. 2012
1.6”
2.9”
5.3”
Rack Standoff Brackets
Part Number(s): RSB1A, RSB1B, RSB1C
INSTALLATION INSTRUCTIONS
CM565
Top V i e w
RSB1A
All Rack Standoff Bracket Kits contain the following components:
• (2) 1RU Mounting Brackets
• (4) #12-24 X 1/2" Bonding Screws
Brackets are designed to mount 1RU equipment.
Top View
RSB1C
Multiple RU equipment will require (2) sets of Rack Standoff
Brackets.
Installing Standoff Brackets to Rack
Install brackets on rack using #12-24 X 1/2" Bonding Screws at desired RU location.
Notes: Minor flanges on brackets must be placed inward toward the rack center as shown.
Rack brackets must align horizontally.
Rack
Standoff Brackets
RSB1B
Top V i e w
#12-24 X 1/2"
Bonding Screws
Detail View
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
#12-24 X 1/2"
Bonding Screws
Page 2
© Panduit Corp. 2012
PatchRunner
High Capacity
Vertical
mounting
position on
rack
Fully back
extended
Standard
Mounting
Fully
forward
Standoff bracket selection to have vertical cable
manager and horizontal cable manager finger
and door alignment
INSTALLATION INSTRUCTIONS
CM565
Securing Standoff Brackets
Using a phillips screwdriver through the front clearance holes
in the bracket, tighten the #12-24 Bonding Screws. The
clearance holes are obround and are at the top and bottom of
Installing 1RU Horizontal Equipment
Install 1RU horizontal equipment (horizontal manager, patch
panel, blanking panel, etc.) onto brackets using screws supplied with the piece of equipment being installed.
the bracket.
Phillips Screwdriver
1RU Horizontal Manager
Screws supplied with
horizontal equipment
Completed Assembly
The Rack Standoff Brackets are designed to mount horizontal managers spaced off of rack equipment rails in order to match up the front of
the horizontal managers with the front of the vertical managers.
Standoff
Bracket to use
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
extended
Top View
Installing Multiple RU Horizontal Equipment Using Rack
Standoff Brackets
Multiple RU equipment will require (2) sets of Rack Standoff Brackets. These
will be mounted on the outer ends of the equipment as shown.
3RU Horizontal Manager
(2) Rack Standoff Brackets
mounted to each side
E-mail:
cs@panduit.com
www.panduit.com
Page 2 of 2
Fax:
(708) 444-6448
Loading...