Panduit R2P, R2PWH Installation Manual

© Panduit Corp. 2010

Cable Management Numbers-Up Style Racks

Part Numbers:R2P48, R2P, R2PS, R2PW,R2P96

INSTRUCTIONS CM458

Mounting Configuration

3/8” Nut 3-8X1” Bolt

3/8” Paint Piercing Washer

RACK ASSEMBLY

Apply Antioxidant Paste to painted surfaces that the 3/8 paint piercing washers will come in contact with. Install
top angles to upright channels using (2) 3/8x1” bolts (2) 3/8” nuts and (4) 3/8” paint piercing washer (see figure
below) per angle. Finger tighten only.

Apply Antioxidant Paste to painted surfaces that the 3/8 paint piercing washers will come in contact with.Install
the base angles to the vertical upright channels using (4) 3/8x1” bolts (4) 3/8” nuts and (8) 3-16 paint piercing
washers (see figure below) per angle. Finger tighten only.

Stand rack upright. Square the upright channels with the base using a carpenter square. Completely tighten

all bolts to at least 14 ft.-lbs(19.0 N-m).

Top Angle

Antioxidant Paste

3/8X1” Bolt

MOUNT RACK TO FLOOR

Securely mount the rack to the floor using the appropriate
hardware based on the floor construction (concrete,
raised floor, or wood). Note: Mounting using the holes
closest to the rack will minimize deflection.

For Instructions in Local Languages

www.panduit.com/resources/install_maintain.asp

and Technical Support:

3/8 Paint Piercing Washer

15.0

3/8 Nut

6.0

16.0” = 19” RACK

20.0” = 23” RACK

20.3” = 19” RACK

24.3” = 23” RACK

Rack Channel

6.5

9.5

1.25” TYP

12.5

Note: The maximum weight load of the rack is 1,000 pounds with the exception of the
R2P48, which is 300 lbs. The weight should be evenly distributed across the height of the
rack, with the heaviest components mounted at the bottom of the rack. The top angles
are not intended to support a significant load.

E-mail:

[e-mail]

Fax:

www.panduit.com

[phone]

Page 1 of 1