Page 1
Retro-Fit Kit for PANZONE Wireless Enclosure
Part Number(s): PZWRKA
© Panduit Corp. 201 1
Retro-Fit Kit Components:
Door
This Retro-Fit Kit is designed specifically for use with the PZWIFIED Wireless Enclosure.
Mounting Bracket
INSTALLATION INSTRUCTIONS
(4) #8-32 X 1/4”
Screws
(2) Hinge Pins
(4) #8-32 Hex Nuts
Door Replacement
Step 1: Disconnect grounding wire from door to be removed. See Figure 1.
Step 2: Remove lock from door by removing nut on inside door face. See Figure
1.
Step 3: Remove hinge pins from door to be removed using a hammer and a small
gauge steel pin. See Figure 1.
Step 4: Remove old door. See Figure 1.
Step 5: Align hinges of new door to enclosure. See Figure 2.1.
Step 6: Add hinge pins to assembly using a hammer and a small gauge steel pin.
See Figure 2.2.
Step 7: Reconnect grounding wire. See Figure 2.3.
Step 8: Reinstall lock onto door. Be sure to maintain the same lock orient ation
as when it was removed in Step 2. See Figure 2.3.
Grounding Wire
CM545
Complete In-Ceiling Enclosure
Assembly with Retro-fit Parts
and Wireless Access Point
Hinge Pins-Remove using
hammer and small gauge
steel pin
Figure 2.1
Figure 2.2
Door Hinges
New Door
Hinge Pins-Install using
hammer and small gauge
steel pin
Lock
Remove lock
from old door
Grounding Wire
Figure 1
Figure 2.3
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Door to be
removed
Page 2
© Panduit Corp. 201 1
INSTALLATION INSTRUCTIONS
CM545
Mounting Bracket Replacement
Step 1: Remove old Wireless Access
Point (WAP) from enclosure. See Fig.
3.1.
Step 2: Remove old WAP Mounting
Bracket by removing the hex nuts attaching it to the enclosure. See Figure 3.2.
Step 3: Reattach Hex Nuts to studs in
enclosure, but do not tighten. See Fig.
3.3.
Step 4: Using orientation shown, attach
Retro-Fit mounting bracket through larger
part of keyholes, then push bracket
toward top of enclosure to hold in place.
See Figure 3.3.
Step 5: Tighten hex nuts through clearance holes using 11/32” Nut Driver or
Socket Wrench. See Figure 3.4.
Step 6: Align new WAP Mounting
Bracket with the Retro-Fit Mounting
Bracket and secure in place using provided hardware. See Figure 3.5.
Step 7: Attach new WAP in place using
hardware provided with the WAP. See
Figure 3.6.
Enclosure in ceiling
Figure 3.1
Do not tighten nuts
Old WAP Mounting
Bracket removed
WAP
Figure 3.2
Orientation of
Mounting Holes
Installed Retro-fit
Mounting Bracket
Retro-fit Mounting
Bracket
Figure 3.3 Figure 3.4
New WAP Mounting
Bracket
Top of
enclosure
Tighten nuts through clearance
holes using 11/32” Nut Driver or
Socket Wrench
New WAP
Figure 3.5
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
Figure 3.6
cs@panduit.com
(708) 444-6448
E-mail:
Fax:
Loading...