Page 1
Pan Zone Wireless Enclosure with Integrated
Ceiling Tile Bezel
Part Number: PZWC35I
© Panduit Corp. 2010
Part Includes the following Hardware:
(4) #6-32 X 5/16" Screws (1) 20" Long 10 AWG Grounding Wire
(2) Pieces of Fire Resistant Foam (2) Keys
INSTALLATION INSTRUCTIONS
Installation to Ceiling
Wireless Enclosure with Integrated
Ceiling Tile
Ceiling Tile Bezel
CM495
Step 1: Remove 24" X 24" section of tile from the ceiling where
the Wireless Enclosure with Integrated Ceiling Tile Bezel is to
be installed.
Step 3: Hanger wire should be used to hang the enclosure
within a suspended ceiling. Important: Verify hanger wire meets
local building code. Note: There is room in the enclosure for a
power supply or for slacking communication cables. The
enclosure is rated to hold up to 10 lbs of equipment. The weight
of the enclosure, mounting brackets, and equipment does not
exceed 20 lbs.
Holes for installing hanging
wire (2 on each side)
Knockouts for
installing conduit
Step 2: Replace removed ceiling tile with Wireless Enclosure with
Integrated Ceiling Tile Bezel and secure to ceiling.
Releasing Wireless Access
Point Mount Plate
To release wireless access point mount plate, use provided
key to unlock plate from the locking mechanism
Wireless Access Point Mount Plate
Key
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2010
INSTALLATION INSTRUCTIONS
Wireless Access Point Installation
Connecting Groung Wire
AP-Low Profile Bracket: Connect Panduit-
supplied grounding wire to stud on vendorsupplied wireless access point mounting plate.
Secure with vendor supplied nut.
AP-Universal Bracket: Secure Panduit-supplied grounding wire behind vendor-supplied
wireless access point mounting bracket in orientation shown using vendor-supplied screw.
CM495
Access Point-Low Profile Bracket Access Point-Universal Bracket
In both cases, the free end of the grounding
wire will be attached to stud located on the
base of the enclosure.
Installing Vendor-supplied WAP Mounting
Brackets
AP-Low Profile Bracket: Mount vendor-sup-
plied wireless access point mounting plate to
The Panduit-supplied Wireless Access Point
Mounting Plate using Panduit-supplied (4) #632 X 5/16" Screws. Holes are aligned to outer
rectangular orientation of holes on the mounting plate.
AP-Universal Bracket: Mount vendor-supplied wireless access point mounting frame to
The Panduit-supplied Wireless Access Point
Mounting Plate using Panduit-supplied (4) #632 X 5/16" Screws. Holes are aligned to inner
rectangular orientation of holes on the Panduit-supplied mounting plate.
Attached grounding wire
#6-32 X 5/16" Screws
Vendor-Supplied wireless
access point mounting plate
Studs
#6-32 X 5/16" Screws
Vendor-Supplied wireless
access point mounting plate
Studs
Installing Wireless Access Points
Both Bracket styles: Mount wireless access
point using the studs on the back of the wireless access point to connect it to the vendorsupplied wireless access point mounting
bracket. Align studs with corresponding holes
and push to the right to connect.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
Wireless Access Point
www.panduit.com
Page 2 of 2
Wireless Access Point
E-mail:
cs@panduit.com
Fax:
(708) 444-6448
Loading...