Page 1
PANZONE Wall Mount Cabinet
Part Numbers: PZC12S, PZC12P, PZC12W
© Panduit Corp. 2017
Cabinet with Solid Door
PZC12S
INSTRUCTIONS CM315A
PZC12P
Cabinet with Perforated Door
PZC12W
Cabinet with Windowed Door
Location Footprint
25.6"
2.3"
19.7"
Mouunting
Holes
6.5"
Cabinet depth is 22.9” in
closed position
43.0"
Footprint with Cabinet Open
25.0"
Cabinet Width
16.0"
Mounting Holes
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 1 of 4
Page 2
INSTRUCTIONS CM315A
PANZONE Wall Mount Cabinets can be installed in a hinged right or hinged left
application. For your installation, determine which side of the cabinet will hinge.
The cabinet is shown hinged right. Rotate the cabinet 180 degrees for the left
hinge application. Mounting surface must have sufficient strength to support
the cabinet with payload. The mounting surface must also be flat and extend
beyond the overall cabinet footprint.
2” or 3” Conduit Knockout
2” Conduit
Knockout
Front Door
with Lock
7/8” or 1 1/8” Conduit Knockout
Step 2:
Install door by pressing(2) hinges provided in locations shown below.
7/8” Conduit Knockout
Wireless Access
Point Knockouts
Step 1:
Install (4) 3/8” mounting hardware (not provided) as shown in Location
Footprint. Hardware should protrude 3/8” from wall. Mount the cabinet
to the wall by hooking the keyholes over the protruding 3/8” mounting
hardware. Once the cabinet is in place, carefully swing cabinet from
wall and tighten the hardware securely.
Step 3:To adjust the depth of the mounting rail for specific
applications, remove the mounting screws and lockwashers,
move the rail to the desired position and re-install mounting
hardware.
Door Hinges
Mounting Hardware
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 2 of 4
Mounting Rail
Page 3
INSTRUCTIONS CM315A
Cable Routing
Cable must be routed with an adequate slack loop to prevent cable damage. Route cable to point 1 secure to tie down with a T
route cable across the bottom of the enclosure to point 2 secure to tie down with a TAC-TY. Route to the desired patch panel after securing
the cables with a Tac-Ty at point 3 or 4.
Point 4
AC-TY. Next
Point 1
Point 3
Cables Extend
to Patch Panel
Point 2
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 3 of 4
Page 4
Optional Accessories
INSTRUCTIONS CM315A
PZC12S
Cabinet with Solid Door
PZC12P
Cabinet with Perforated Door
PZC12W (Shown)
Cabinet with Window Door
PZCHSM2
ANZONE Horizontal Slack Manager
P
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
PZBR4
ANZONE 4” Bend Radius Post Kit
P
www.panduit.com
Page 4 of 4
PZCRR
ANZONE Rear Equipment Rail Kit
P
PZCFK
ANZONE Fan Kit
P
E-mail:
cs@panduit.com
Fax:
(708)444-6448
Loading...