Panduit PVQ-PS12VDC-S Installation Manual

Power Supply

1.

Panel Manager (PM)

Strain Relief with Pan-Ty cable tie

ATTENTION:

Observe precautions for handling electrostatic
sensitive electronic devices when installing this
product. Ensure you are properly grounded with a
wrist strap or equivalent while installing this product.

PanView iQ (PViQ) Panel Manager (PM) Power Supply

Part Numbers: PVQ-PS12VDC-*

© Panduit Corp. 2011

INSTALLATION INSTRUCTIONS

Attaching Power Supply

Attach the appropriate end of the AC cord to the power supply. Then insert the power
supply’s radial plug into the PM. Once the power cord is plugged into the PM, it can be
secured to the PM strain relief with a Pan-Ty cable tie, as shown above. Care should be
taken when removing the cable tie (if required) so as not to damage the power cord.

* Denotes regional part numbers: S (North America), E (Europe), U (U.K.), J (Japan), C (China)

Page 1 of 2

MN017A

PViQ European (EMC) Warning:

This product is not intended for use in a residential
environment. Use of this product in residential areas
may cause electromagnetic interference.

E-mail: [e-mail] Technical Support: www.panduit.com/resources/install_maintain.asp Phone: [phone]

© Panduit Corp. 2011

2.

Wrap Tak-Tape
around power
supply and cable
managers.

Loop DC power
cord over cable
manager

For additional mounting options,
visit the Technical References
section of the Panduit Physical
Infrastructure Management site at:

www.panduit.com/pim

3.

INSTALLATION INSTRUCTIONS

MN017A

Power Supply Mounting Option

Mount the power supply to vertical cable managers or rack rails on the back side of an installation
using Panduit Tak-Tape (Part # TTS-20R0).

Once positioned, loop the DC power cord over a cable manger finger that is at least one space
above the power supply to ensure proper bend radius of power cord. Let the DC power cord hang
down on the opposite side of the cable managers.

Next, wrap Tak-Tape around both the power supply and the cable managers (as shown above).

Page 2 of 2

Plugging in the Power Supply

Lastly, connect the power supply to an AC power
source.

WARNING:

When mounting or placing power supplies within
your rack or rack cabinets, it is necessary to ensure
proper airflow for heat dissipation by maintaining a
separation of 1" of open space between power
supplies. Avoid stacking or confining power supplies
to protect equipment and avoid thermal overload.

E-mail: [e-mail] Technical Support: www.panduit.com/resources/install_maintain.asp Phone: [phone]