Page 1
EASY PAYOUT PACKAGING FOR COPPER CABLE
®
REELEX
SYSTEM PACKAGING
© Panduit Corp. 2019
INSTALLATION INSTRUCTIONS
PN638
Handling, Payout and Use
Orientation Packages should be orientated so that the payout hole faces the direction the
product is being pulled from.
DO NOT dispense the product with the coil in the horizontal position as this may
cause tangling. Make sure the coil is always upright.
Losing the End If the product falls back into the hole, the installer should access the inside
diameter of the coil though the access panel, or by opening the package and
thread the inside end back through the payout tube.
Resolving Tangles If a tangle or snag does occur, often it is caused by improper box size or opera-
tor error when packaging.
Most tangles can be resolved by accessing the inside of the coil through the
access panel or by opening the package. Make sure the inside layers of the coil
are not getting in the way of the product paying out. If a knot does occur, either
resolve it inside the package, or try to pull it through (only on REELEX® II).
Handling, Palletizing and Shipping
Orientation Packages should be placed on a pallet with the coils upright. If the packages
are placed horizontally, the product inside can come out of place and cause
knots or tangling.
When stacking packages on the pallet, take a look at which direction the flutes
(or grooves) in the cardboard go. To prevent crushing, these flutes must be
vertical to provide support for the next layer.
D-2000 boxes are slightly different in design compared to standard
REELEX® II boxes. Boxes designed for the D-2000 have exposed flaps where
the panels are glued together. When stacking these boxes on a pallet, stack
each layer 180-degrees from the layer below so that the glue flaps interlock (bottom left). This method adds stability when shipping.
Overhang Do not allow the packages to overhang the pallet as the product could become
damaged.
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2019
Paperboard
flute direction
must be vertical
when stacked.
Paperboard
flute direction
must be vertical
when stacked.
Paperboard
flute direction
must be vertical
when stacked.
INSTALLATION INSTRUCTIONS
Standard REELEX® (Small Payout Tube) Palletizing
REELEX® II (Large Payout Tube) Palletizing
Fold-Tab Boxes (Hand-Packed)
PN638
Glued Boxes (Assembled on D-2000)
REELEX® is a registered trademark of REELEX® Packaging Solutions, Inc. in the United States and/or other countries.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...