Vinyl Insulated Multi-Tap and In-Line Splicer/Reducer
Aluminum Mechanical Connectors
C
Panduit Corp. 2016
INSTALLATION INSTRUCTIONS T-PMPI-266-PC
1. Remove caps from wire and screw ports which are to be utilized.
2. Strip wire insulation to length shown on label. Do not nick or ring
conductor strands. For aluminum wire, the stripped wire should be
wire brushed to remove oxide film
3. Insert wire fully into open port of connector. (One wire per port only).
Rotate wire in port to disperse anti-oxidant.
4. Tighten clamping screws to torque value shown on label.
5. Replace caps in screw and unused wire ports.
Panduit Multi-Tap Connectors with Isolated Mounting Holes should be installed
in compliance with the current National Electrical Code and Canadian Electrical code
Mounting hardware shall be 1/4" in diameter and shall be appropriate for the mounting surface.
Mounting hardware shall not cut or penetrate in any way the insulation isolating the mounting holes.
Doing so will compromise the function of the connector and void all warranties.
Any electrical product can cause electrical shock or fire hazard when installed or used improperly.
All Panduit Multi-Tap Connectors with Isolated Mounting Holes are Listed to U.S. and Canadian safety
standards when installed in conformance to the above codes.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 1 of 1
E-mail:
cs@panduit.com
Fax:
708-444-6993
Rev 03
Loading...