Page 1
NET-A
CCESS
N-Type Network Cabinets
(PDU Bracket Kit - NVPDUB
)
© Panduit Corp. 2012-2015
INSTALLATION INSTRUCTIONS CM608A
PDU Bracket Kit Installation (optional)
• Install [4] M5 Torx Screws into desired top location of cabinet post, as shown below
• Do not tighten screws - Leave a gap between screw and cabinet post for bracket thickness
• Place Top PDU Bracket over screw heads and slide up (or down, depending on mounting side of cabinet)
• Install Bottom PDU Bracket at desired distance from Top PDU Bracket
• Tighten [8] M5 Torx Screws
PDU Bracket
LEFT SIDE:
Slide down
RIGHT SIDE:
Slide up
DO NOT TIGHTEN
(Leave Gap Between
Screw and Cabinet Post)
[4] M5 Torx Screws
(use T25 Torx bit)
NOTES:
• Panduit recommends installation of NVPDUB
brackets prior to positioning of cabinets in row
• An angle impact driver (such as Makita® BTL061)
is recommended when installing NVPDUB brackets
on cabinet positioned in row
Top PDU Bracket
PDU Bracket
(installed)
Bottom PDU Bracket
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Loading...