Panduit NET-ACCESS CN3, NET-ACCESS CN7018-EXT, NET-ACCESS CNAE7018, NET-ACCESS CNPS7018 Instructions Manual

© Panduit Corp. 2008

NET-ACCESS Cabinet for Cisco Nexus 7018 Switch

INSTRUCTIONS CM385

Component Guide

CN3

(1) Base Cabinet
(2) Cable Management Finger Kits
(1) Hardware Kit
(2) #12-24 Threaded Equipment Rail Sets

(2) Top Side Extensions
(2) Top Front/Rear Extensions
(2) Bottom Door Shoe Extensions
(2) Bottom Side Extensions
(2) Split Door Sets
(2) Vertical Side Supports
(1) Hardware Kit

For installation instructions for the CN3 cabinet, please reference

CN7018-EXT

CNAE7018

(1) Inlet Duct Assembly
(1) Exhaust Duct Assembly
(1) Bottom Duct Assembly
(5) Mounting Brackets
(1) Hardware Kit

instruction sheet CM317B.

CNPS7018

(2) Side Panels
(2) Lower Horizontal Supports

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp

Page 1 of 8

INSTRUCTIONS CM385

Top Cap Extension Assembly

Installation of Top Side Extensions

Install (2) top side extensions, using (2) 5/16” serrated flange lock nuts on each extension (there are pre-installed 5/16” press-studs in side
extensions). Remove knock-out feature from original top cap if necessary. Do not tighten side extensions until front and rear extensions are
mounted and aligned with original top cap. Top front and back extension installation is shown at the bottom of this page.

Side Extensions

Assembled

Remove Knock-outs
(if necessary)

5/16” Serrated Flange
Lock Nut

Installation of Top Front and Back Extensions

Attach (2) top front and rear extensions, using (4) #10-32 nuts and (4) #10 lockwashers per extension piece (there are (4) pre-installed #10
press-studs in each extension). Align all top extension parts, leaving a minimal gap between side and front/rear parts. Secure side extensions
by tightening (4) 5/16” serrated flange lock nuts.

Rear Extension

Front Extension

Assembled

See Detail View

#10-32 Nut

#10 Lockwasher

For Technical Support: www.panduit.com/resources/install_maintain.asp

Page 2 of 8

INSTRUCTIONS CM385

Door Shoe Extension Assembly

Installation of Front and Back Bottom Door Shoe Extensions

Install (2) door shoe extensions to existing cabinet door shoes using (6) #12-24 pan head phillips screws on each side and (6) #12 lockwashers;
(4) screws vertical on front and (2) screws horizontal from behind. Center extension by installing a screw through the centering hole first,
followed by installing the remaining screws through slots as shown.

#12-24 pan head
Door Shoe
Extension

Existing Cabinet
Door Shoe

phillips screws and

#12 lockwashers

Installation of Bottom Side Extensions

Centering Screw

Assembled

Centering Hole

Install (2) bottom side extensions as shown. Secure using (2) #12-24 serrated hex head screws on each extension.

Assembled

Bottom Side
Extension

#12-24 serrated
hex head screws

For Technical Support: www.panduit.com/resources/install_maintain.asp

Page 3 of 8