Page 1
NET-A
(NACSS, NERSS Slack Spool Kits
© Panduit Corp. 2013
CCESS
INSTRUCTIONS CM665
N-Type Switch Cabinets
)
Install Slack Spool Brackets
• NACSS - Locate mounting position for Center Bracket Assembly. Loosen adjusting screws on
bracket and adjust bracket width to allow for tight fit between [2] ganged cabinets and tighten adjusting
screws, if necessary. Secure Center Bracket Assembly to cabinet posts with [4] M5 Torx screws.
• NERSS - Locate mounting positions for Left and Right End of Row Brackets. Secure Left and Right
End of Row Brackets to cabinet posts with [2] M5 Torx screws per bracket.
NERSS - Right Slack Spool Bracket
Front of Cabinet
NACSS - Center Slack Spool Bracket
[2] M5 Torx Screws
(use T25 Torx bit)
NERSS - Left Slack Spool Bracket
[2] M5 Torx Screws
(use T25 Torx bit)
[2] M5 Adjustment Screws
(use T25 Torx bit)
[2] M5 Torx Screws
(use T25 Torx bit)
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
INSTRUCTIONS CM665
Install Slack Spools
• Align Slack Spool mounting tabs with keyholes of Slack Spool Bracket(s)
• Insert mounting tabs through keyholes
• Push downward until Slack Spool clicks into place
• Pull angled flange to release and un-install Slack Spool
Align Slack Spool mounting
tabs with keyholes of Slack
Spool Bracket(s)
Pull Angled Flange to release
and un-install slack spool
Push downward
until Slack Spool
clicks into place
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
techsupport@panduit.com
Phone:
866-405-6654
Loading...