Panduit NCMHAEF2, NCMHAEF4 Installation Manual

Page 1
© Panduit Corp. 2003
Network Cable Management
Horizontal Active Equipment Front Only
Part Numbers: NCMHAEF4, NCMHAEF2
INSTRUCTIONS CM273A
Open
Release Tab
NCMHAEF4
MANAGER
NCMHAEF2
CABLE CAPACITY
UTP Cable
To remove hinged cover, deflect the release tab and slide the door off the hinges.
Note: Cable tie on fingers is for packaging only.
19” Rack Mounting
.187 Dia
NCMHAEF4
Method 1
Method 2
NCMHAEF2
Method 1
Method 2
When routing the cables from the active equipment up to the manager, either of the following two methods is recommended to help maintain cable bend radius. METHOD 1: Route half of the cables from the active equipment cards vertically through the manager fingers slots, then horizontallyinto the vertical pathway. Repeat process for the other half of the cables routing them in the opposite direction. METHOD 2: R oute all cables in one direction from the cards vertically through the manager fingers slots, then horizontally
into the vertical pathway.
METHOD 1
480
288
240
144
#12-24x.5 or M6 Screws
Use screws (provided) to mount on a 19rack above the active equipment.
METHOD 2
Finger Slot
Vertical Card
Active Equipment
For Worl dside Subsidiaries and Sales Offices visit Web Site: ww w.panduit.com
Finger Slot
Vertical Card
Active Equipment
Technical Support Phone: 866-405-6654 Fax: 708-444-6993 e-mail: ncginfo@panduit.com
Loading...