Panduit N51SPS Installation Manual

NET-A

(Side Panels - N21SPS, N51SPS, N22SPS, N52SPS

© Panduit Corp. 2013-2014

CCESS

INSTRUCTIONS CM614A

N-Type Network Cabinets

Side Panel Support Bracket Installation

• Secure Side Panel Support Bracket to cabinet frame with [2] M5 Torx Screws.

)

Side Panel Support
Bracket

[2] M5 Torx Screws
(use T25 Torx bit)

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp

Page 1 of 2

INSTRUCTIONS CM614A

Side Panel Installation

• Rear Side Panel with Bumper Plate to be installed first.

• Remove [2] top Cover Plates of Rear Side Panel by pulling plunger slightly to release Cover Plate. (Bumper Plate will be to center of
cabinet.)

• Tilt the Rear Side Panel and insert [2] bottom Hinge Pins into bushing and slot of Support Bracket. Pull top Spring Loaded Hinge Pins
and engage with cabinet frame and Top Cap.

• Ensure Catch Plate on Front Side Panel is facing center of cabinet. Pull and lock [3] Spring Loaded Hinge Pins of Front Side Panel
leaving the bottom rear hinge pin in the released position. Insert bottom rear hinge pin into bushing of Side Panel Support Bracket..
Release rear top Spring Loaded Hinge Pin and ensure that panel is engaged with cabinet frame. Close Panel and release front Hinge
Pins.

• REVERSE STEPS to remove In-Row Side Panels

IMPORTANT: Remove Rear Split doors prior to Removal and Installation. Install Rear Side Panel First

Bumper Plate

Spring Loaded Hinge Pin
(Top and Bottom)

Front

Plunger

Grommet

For Instructions in Local Languages

and Technical Support:

www.panduit.com/resources/install_maintain.asp

Rear Side Panel

Cover Plate

Front Catch Plate

www.panduit.com

Move Finger Pull into
Slot to Lock Hinge Pin
in

OPEN position

(Front Side Panel only)

Front

Rear Side Panel

Front Side Panel

E-mail:

[e-mail]

Phone:

866-405-6654

Page 2 of 2