Page 1
COPPER COMPRESSION CONNECTORS
C
Panduit Corp. 2016
INSTALLATION INSTRUCTIONS T-PMPI-235-PC
COPPER COMPRESSION CONNECTOR INSTALLATION
1. Use a connector marked for the wire size and wire material to be used. NEVER
use a copper conductor on aluminum wire.
2. Strip wire insulation to approximate length shown on tool chart. DO NOT nick
or ring the conductor strands.
3. Clean the wire.
4. Insert stripped wire into connector until the wire stops.
5. Using installation tooling shown on other side, insert connector in die and crimp
between color bands or knurl markings. REQUIRED NUMBER OF
COMPRESSIONS SHOWN IN ( ).
6. After crimping, inspect for sharp edges, flash or burrs and remove if present.
HEAT SHRINK INSULATION INSTRUCTION
1. Refer to Panduit catalog or www.panduit.com for heat shrink material information,
tubing size, voltage rating, and shrink temperature.
2. Cut tubing to length allowing insulation coverage as desired. Allow a minimum
of 1-1/2" inch overlap on wire insulation.
3. Shrink with a standard propane torch or heat gun. MOVING FROM CRIMPED
PORTION OF CONNECTOR TOWARD INSULATED WIRE. Adhesive flow at
ends indicate shrinkage complete.
*Tested by TELECORDIA
meets NEBS Level 3
*Heat shrink insulation and blank tongues not tested by TELECORDIA
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Rev 04
Page 2
C
Panduit Corp. 2016
INSTALLATION INSTRUCTIONS T-PMPI-235-PC
Tool Chart for Compression Connectors
Type LCCF with Copper Flex Cable
* CD-940 dies to be used exclusively with CT-940CH and CT-2940 tools.
** CD-920 dies can be used with CT-940CH and CT-2940 tools with CD-940-DA die adapter.
Tool Chart for Compression Connectors
Type LCAF and SCSF with Copper Flex Cable
* CD-940 dies to be used exclusively with CT-940CH and CT-2940 tools.
** CD-920 dies can be used with CT-940CH and CT-2940 tools with CD-940-DA die adapter.
*** CT-920, CT-920CH, & CT-2920 tool maximum splice size is SCS300.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
cs@panduit.com
Phone:
800-777-3300
Rev 04
Loading...