Page 1
ALUMINUM MECHANICAL
CONNECTOR INSTALLATION
C
Panduit Corp. 2016
WIRE:
Strip wire immediately prior to installation. Do not score strands. Clean wire with a wire brush
or abrasive cloth. When using aluminum wire, immediately coat with joint compound CMP-100
INSTALLATION INSTRUCTIONS T-PMPI-223-PC
NUT:
Tighten until compression washer is flat.
See page 2 for tightening torque specifications.
COMPRESSION WASHER:
label.
Cup side down. Part number is on
FLAT WASHER PLATED:
CONNECTOR:
connector.
See that wire size is within range stamped on
Must be larger than compression washer.
MOUNTING SURFACE:
compound CMP-100
For Technical Support: www.panduit.com/resources/install_maintain.asp
Wire brush if not plated. Coat with joint
Page 1 of 2
Page 2
INSTALLATION INSTRUCTIONS T-PMPI-223-PC
Torque Chart for Aluminum Mechanical Connectors
Types LAMA, LAMB, LAM2A, LAM2B, LAM2SB, LAM3B, LAM3SB, LAM3D,
LAM4SB, LAM4D
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
www.panduit.com
Page 2 of 2
E-mail:
cs@panduit.com
Fax:
708-444-6993
Rev 05
Loading...