Panduit IAEFP2-2G Installation Manual

IndustrialNet Stainless Steel

Bulkhead Faceplates

Part Numbers: IAEFP1, IAEFP2-2G

© Panduit Corp. 2012

Faceplate must be used with supplied gasket and screws,
mounted onto a smooth flat surface, and installed with any
IndustrialNet connectors or couplers to achieve an IP67 rating.

While holding Bulkhead in place, secure with Nut on back side
of faceplate. Be careful not to tighten to the point the Bulkhead
Seal is over compressed and displaced from the faceplate and
the Bulkhead.

Note: If using wrench, flats on nut should be on outside. Hand
turn Nut 4-1/4 to 5 full turns.

INSTALLATION INSTRUCTIONS

IAEFP1 IAEFP2-2G

Page 1 of 1

PN434A

Screws

Bulkhead

Seal

Bulkhead

Faceplate

E-mail: [e-mail] Technical Support: www.panduit.com/resources/install_maintain.asp Phone: [phone]

Gasket

Nut