Page 1
Surface Preparation for Good Electrical Bond
Installing One Shielded Wiring Duct
Anti-Oxidizing Compound
10-32 x 1/2" Screws
(or sheet metal screw
equivalent) to be supplied
by the installer or end user
- OR -
NR1-C, NR1-M Rivet
(sold separately)
Remove paint
to bare metal
1"
2"
Control panel
surface
Anti-Oxidizing
Compound
Screw
Repeat for each screw location
3.
at duct ends and/or T-intersection
Screws
Screw or NR-1 Rivet
2" max 2" max
(sold separately)
Control
panel
surface
4A.
Prepared
surfaces
(see step 3)
Panduct PanelMax Shielded Wiring Duct
Cutting Shielded Wiring Duct to Required Length
CWST Wire Snipping Tool
(sold separately)
G2X2LG6EMI
G2X3LG6EMI
G2X4LG6EMI
Remove from
CWST
both sides
1.
DCT
2" max
2.
DCT Duct Cutting Tool
(sold separately)
For Use with Type C Cover and Compatible with
Panduct PanelMax Noise Shield and Panduct Divider Walls
Part Numbers: G2X2LG6EMI, G2X3LG6EMI, G2X4LG6EMI
© Panduit Corp. 2011
INSTALLATION INSTRUCTIONS
EP001
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
Page 2
© Panduit Corp. 2011
Installing Two Shielded Wiring Duct in a T-intersection
10-32 x 1/2" Screws
(or sheet metal screw
equivalent) to be supplied
by the installer or end user
- OR -
NR1-C, NR1-M Rivet
(sold separately)
Optional - Sidewall Breakout for Creating T-intersection
CWST Wire Snipping Tool
(sold separately)
DNT-100 Duct Notching
Tool (sold separately)
Screws
Screw or NR-1 Rivet
(sold separately)
2" max
2" max
Sidewall
Align screws
breakout
(Remove
section 2-3
finger wide
Duct #2
Control
panel
Prepared
surfaces
as needed)
surface
Duct #1
4B.
(see step 3)
CWST
1.
3.
DNT-100
2.
Optional - Sidewall Finger Removal
1.
2.
Remove Only
As Required
Removing bridge
connectors
between fingers
will reduce local
noice reduction
capability.
CAUTION
Foil edges may
be sharp.
INSTALLATION INSTRUCTIONS
EP001
For Instructions in Local Languages
www.panduit.com/resources/install_maintain.asp
and Technical Support:
For Use of Panduct PanelMax Noise Shield (SD2EMI, SD3EMI, SD4EMI) with Panduct
PanelMax Shielded Wiring Duct, Reference Installation Instructions RW260
www.panduit.com
Page 2 of 2
E-mail:
cs@panduit.com
(815) 328-2001
Fax:
Loading...